Love The Drive Solara Wind Deflector 2005 to 2010 - Manual (Page 2)

Step 1: Your wind deflector attaches to the small
holes in the rear trim panel. There are two "L"
handled spring plungers. The "nose" of the plungers
will go into the holes. Start with the plungers in the
closed position as shown in the top right photo.
Step 2: Lower the wind deflector into the
back seat area. While still holding on the
back of the wind deflector, line up the
plunger with the hole in the trim panel.
Step 3:Turn the handle to release the
plunger, the nose will enter the hole and
hold the wind deflector in place. Repeat
this on the other side.
Step 4: The two
front brackets will
rest o the top of
the trim panel.
Step 5: There are
also two straps that
attach to the
bottom of the trim
panel (below the
back seat) and then
to the buckle under
the front brackets.