Love The Drive Mustang compatible with lightbar Wind Deflector 2005 to 2014 - Manual (Page 2)

Step 1: Start by lowering the folded wind
deflector into the back seat area so the
brackets fit onto each side of the trim panel. Below is a close up to show the two brackets
on the trim panel on one side. You may need
to adjust the rear brackets to fit tightly against
the trim panel.
Your wind deflector is
designed not to touch your
light/style bar. It should sit
1/4 of an inch way from
your lightbar.
Step 2: Next you need to
attach the four straps.
The
two rear straps with the black
snap hooks will clip onto the
child seat anchoring system.
Once all four of
the straps are
connected,
tighten each
strap but not
too tight.
On your rear seats there will be a small
circle with a child seat picture to show you
where the anchors are. The black snap
hooks are inserted with the snap facing
down. Slide the hook into the hole, press
down and then pull back up towards you
to secure it into place.