Love The Drive BMW 6 series windstop 650, 640 M6 F12 2011 to 2015 - Manual (Page 2)

When not in use, your BMW 6 windstop
can be stored in the trunk. Please use
the storage bag provided when storing
your wind deflector.
Lower the back of the windstop into the
holes between the rear seat head rests. To
remove the windstop just reverse the
order of the steps.
Lower the windstop till the barrel bolt on your
side alines with the hole in the trim panel. Slide
the bolt into the hole and turn the handle
down so it locks the bolt into place.
Lower the wind deflector into the back seat.
Insert the extend barrel bolt into the hole on
the trim panel, on the opposite side from
which you are standing.
To easily store your windstop in the trunk
you will need to lower the barrel bolts. Loosen
(do not remove) the thumbscrew at the
bottom of the barrel bolt. Remove the top 2
thumbscrews. Slide the bolt down and replace
the thumbscrews in the top holes. Reverse the
steps to move the bolt to the up position.
Loosen the thumb screws on the rear
bracket ( 1 turn counter clockwise (Lefty =
Loosey) . Turn both of the rear brackets so
they face out. Then tighten the
thumbscrews by turning them Clockwise till
they are snug ( Righty = Tighty )