Longevity FORCECUT 40D new - Manual (Page 14)

FORCECUT 40- 40 AMP Plasma cutter 110v/220v
14 | P a g e
Check Prior to Use
1. Check if cutting machine is grounded securely according to standard.
2. Check if all connectors are connected firmly.
3. Check if power voltage is correct.
Basic Operation
1. Ensure that all cables are connected to the machine.
2. Ensure that the machine’s OFF/ON switch is set to OFF, and plug the machine into the
electrical outlet.
3. Connect the air compressor supply line to the air input side on the water separator.
4. Turn the ON/OFF switch to ON. The cooling fans should operate and the ON indicator LED
or power switch (if applicable) should illuminate.
5. Clean the contact point on the work piece to ensure a good electrical connection. Ensure that
no rust of paint is present that could create an open circuit.
6. Connect the ground clamp to the work piece to be cut.
7. Connect the torch to the unit properly.
8. With the pilot arc knob connected, you should get a full continuous arc when the trigger on
the torch is pressed.
9. Depress the button on your torch to start the arc and begin cutting.
10. You can test the air to insure that is it properly flowing by selecting Auto Gas (Air) Flow. Air
will pass through the torch continuously.
11. If necessary remove slag from the under part of the cut using a grinder or chisel after your
cut.