Labnet 311DS Environmental Shaking Incubator (I5311-DS and I-5311-DS-230V) User Manual
Page 2

CONTENTS OF THIS USERS MANUAL
Graphic Symbols
page 1
Controls & Calibration
page 3
Safety Precautions
page 1
Operating the I-5311-DS
page 5
Introduction
page 2
Care and Maintenance
page 5
Specifications
page 2
Troubleshooting Guide
page 6
Unpacking
page 2
Technical Support / Service
page 6
Installation
page 3
Accessories
page 7
GRAPHIC SYMBOLS
Your Labnet I-5311-DS incubator shaker uses internationally accepted graphic symbols to
help convey information to the user and to call the users attention to important safety precau-
tions and guides for using this equipment.
indicates that user should consult manual further description or discussion.
Indicates AC “Power On”
Indicates “Heating”
Indicates “Degrees Centigrade”
Indicates “Temperature”
Indicates Potential “Shock Hazard”
Indicates Protective “Earthground”
SAFETY PRECAUTIONS
Use of this product in any manner not specified by the manufacturer may impair the
safety protection provided by the equipment and may result in physical damage and/
or personal injury. Please read all operating instructions in this manual prior to use of
this equipment.
1. Do not operate this unit in an explosive or flammable environment.
2. Do not incubate or shake flammable or explosive materials or highly reactive chemicals.
3. Lifting / Handling: These units are heavy and care should be taken to use appropriate
lifting devices. Units should only be lifted from their bottom surfaces and not by doors,
handles or knobs.
4. Leveling: The unit must sit level and solidly on the four leveling feet.
5. Load testing: Test all loads to be shaken under observation to insure load and unit
stability.
6. Units are not stackable. Do not stack one unit on top of another unit.