L.A. Baby Full Size Folding Wood Crib CW-983 User Manual
Warning, Strangulation hazard, Fall hazard
THE FULL SIZE FOLDING WOOD CRIB
Warnings & Instructions
Product # 983
Read all instructions and warnings before assembly and
use of crib. B
e sure to check that parts listed below are included
before assembling this crib.
Parts List
Pieces per Unit
A) Rail with mattress support
1
B) Side Rail
1
C) End Panels
2
D) 8
E) 8
F) 8
G) 4
H) Wrench
L-Bolts
Washers
Lock Nuts
Casters
1
Made in China
Step: 1 Drop the latch on one end panel (C ) to keep
panel from folding.
Note: Latches are inside of crib.
Step 2: Start with Side rail (B) (rail without posture
board). Make sure side rail warnings are on top of rail
and can be read from out side of crib.
Insert L-bolts (D) into holes on top and bottom of rail
(A). Insert the threaded ends of the L-bolts (D) into the
end panel (C)as illustrated.
Step 3: Fasten the head board to the rail using one
washer (E) and nut (F). Tighten with the included
wrench (H). Repeat for bottom of panel.
Step 4: Repeat the steps 1, 2, & 3 for the remaining
end panel (C ).
Step 5: Repeat the steps 1, 2, & 3 for each side of
remaining side rail panel (A)
Make sure posture board and side rail are attached
with the hook and loop straps as illustrated
Step 6: Drop the mattress support and fasten it to the
lower horizontal bar of side rail with the “hook and
loop”, fasteners.
C
C
B
D
B
D
C
A
B
C
C
Care Instruction:
Your crib may be cleaned, using a damp cloth and ordinary mild
domestic detergent. Do not use abrasives or bleach. Wipe dry.
Warnings
Step 7: Insert casters (G)
into leg posts.
Step 8: Place mattress
into crib.
Double check that all
hardware is secure
Ins_CW_983_A_032511
A
To store crib, lift posture board and secure
to top of rail with the hook and loops straps
E F
D
G
H
Hardware
C
E
H
F
WARNING!
WARNING!
Any mattress used in this crib must be at least 27 1/4” x 51 5/8” with a thickness not exceeding 6”. Do not use a
water mattress with this crib.
Check this product for damaged hardware, loose joints, missing parts or sharp edges before and after assembly
and frequently during use.
. DO NOT use crib if any parts are missing damaged or broken. Contact “L.A. Baby Juvenile
Products”, for replacement parts and instructional literature if needed. DO NOT substitute parts.
Check fasteners periodically for tightness DO NOT over tighten. This may cause distortion or breakage.
DO NOT place the crib near a window where cords from blinds or drapes may strangle a child.
WARNING!
!
AVOID STRANGULATION: As soon as an infant can sit or stand up, close the crib gate or raise the Drop Front
permanently.
!
! Strings can cause strangulation! DO NOT place items with string around a child's neck, such as hood strings or
pacifier cords. DO NOT suspend strings over a crib or attach string to toys.
!
! When child is able to pull to a standing position, set mattress to lowest position and remove bumper pads, large
toys and other objects that could serve as steps for climbing out.
! DO NOT leave a child in a crib with an open gate or lowered Drop Front. Be sure the gate is closed or the Drop
Front is raised and locked in position whenever the child is in the crib. After closing the gate or raising the Drop
Front, make sure the latches are secure.
! The child must be seated at the rear of the crib when lowering or raising the gate or Drop Front.
! As your child grows, adjust the height of the posture board down so that he/she cannot pull himself/herself out of
the crib.
!
WARNING!
When the child is able to climb out or reaches the height of 35in (90cm), or when the height of the side rail is
less than 3/4 of the child’s height, shall no longer be used.
Replace teething rail if damaged, cracked, or loose
the
Failure to follow these warnings and instructions could result in serious injury or death.
Read all instructions before assembling or using this crib. Keep instructions for future use.
Infants can suffocate
on soft bedding. NEVER add a pillow, comforter, or padding.
!
! To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their back to sleep, unless
otherwise advised by your physician.
!
NEVER use this product if there are any loose or missing fasteners, loose joints, or broken
parts. Check before assembly and periodically during use.
Make sure latches are secure.
Contact L.A.Baby for
replacement parts.
!
!
Strangulation Hazard
Infants can suffocate in gaps between crib sides and a mattress that is too small.
To help prevent strangulation tighten all fasteners. A child can trap parts of the body or clothing on loose
fasteners.
Fall Hazard
! This crib including side rails must be fully erected prior to use. Make sure latches are secure.
!
.
!
! If refinishing, use a non-toxic finish specified for children’s products.
! Follow warnings on all products in a crib
!
Child can become entrapped and die when improvised netting or covers are placed on top of crib.
NEVER add such items to confine child in crib.
!
NEVER use a water mattress with this crib.
! NEVER use plastic shipping bags or other plastic film as mattress covers because, they can cause suffocation.
! This full size crib conforms to
applicable regulations promulgated by the Consumer Products Safety
Commission, specifically requirements of 16 CFR. Part 1219.
!
!
!
!
L.A. Baby Juvenile Products
16039 Loukelton Street
City of Industry, California 91744
Toll free customer service: 800-584-3094
e-mail: [email protected]
This crib conforms to applicable
r e g u l a t i o n s p r o m u l g a t e d b y t h e
Consumer Product Safety Commission.
This crib meets
Federal Standard: 16 CFR 1219
THIS CRIB PASSES COMMERCIAL
CRIB STANDARDS OF A.S.T.M. 2710
Date of MFG.
CAUTION: Any mattress used in this crib must be at least
27 1/4” x 51 5/8” with a thickness not exceeding 6”