L.A. Baby Portable Crib CS-81 - Manual

L.A. Baby Juvenile Products
16039 Loukelton Street
City of Industry, California 91744
Toll free customer service: 800-584-3094
e-mail: [email protected]
www.lababyco.com
The L.A. Baby
Portable Crib
Warnings & Instructions
Product # CS 81
Parts List Pieces per Unit
A / B Crib
C - Posture Board
1
D - Mattress support wires 6
(Factory installed)
E- Mattress, 2” x 24” x 38” 1
F - Swivel Caster 4
1
Made In China
DATE OF MFG
Ins_CS_81_091510
Warning:
See bottom of panel for instruction Sheet and Warnings
!
Read all instructions before assembly and use
of crib.
Place posture board on top of all six wire hangers.
Attach casters to leg posts and set in the mattress.
To store crib, remove mattress and posture board. Fold
crib. Set mattress length side up between rail and end
panel. Insert posture board long side up. (Fig. 3)
Unfold crib
Posture board - Lowest position Posture board - Highest position
Fig. 1
Fig. 3
Fig. 2
D
E
F
C
C
A
B
D
E
F
C
B
A
Use posture board latches
to secure posture board to
mattress support wires. Swing up Mattress support wires 90
degrees to remove or install to
different mattress board height.
Dear Customer,
Thank you for purchasing a L.A. Baby Crib
If you would like more information you can look at our
video on directions by using the following link:
Http://www.youtube.com/lababyco
If this crib is for a newborn the posture board should be in the higher position. To do this, the six mattress support wires (D) should be
moved to the upper holes in the side rails. As the baby grows the six mattress support wires (D) should be moved to the low position. To
change the position of the six support wires (D), swing up each support wire 90 degrees (Fig. 2) and then take out the end of the support
wire that is farthest from you by pushing (see arrow in figure 2 for the part of the support wire to push) on the support wire until the one end
comes out and then remove the other end. Then install the support wire into the hole on the crib in the correct position that you want the
posture board to be in by inserting the end of the support wire into the hole nearest you first and then push on the support wire until the end
farthest from you is installed.(arrow fig 2) Repeat this process until all 6 support wires are installed in the correct position. To secure the
posture board to the crib, be sure to engage the two posture board latches (Figure 1) attached to the posture board.
!
!
WARNING:
FAILURE TO FOLLOW THESE
WARNINGS AND THE INSTRUCTIONS COULD RESULT IN
SERIOUS INJURY OR DEATH.
!
loose joints, or broken parts. Check before assembly and
periodically during use.
Make sure latches are secure. Contact
L.A.Baby for replacement parts.
! NEVER substitute parts
WARNING:
Infants can suffocate.
! In gaps between a mattress too small or too thick and product
sides.
! On soft bedding.
NEVER add a mattress, pillow, comforter, or padding.
WARNING:
! This crib including side rails must be fully erected prior to use.
! When child is able to pull to standing position, set mattress/base to
lowest adjustment position and remove bumper pads, large toys,
and other objects that could serve as steps for climbing out.
! NEVER place a crib near windows where cords from blinds or
drapes may strangle a child.
! Discontinue use of the crib when child is able to climb out or
reaches a height of 35 inches (890 millimeters), the child should be
placed in a youth bed.
! If refinishing, use a non-toxic finish specified for children's
products.
! Child can become entrapped and die when improvised netting or
covers are placed on top of crib. NEVER add such items to confine
child in crib.
! NEVER use a water mattress with this crib.
! Always provide the supervision necessary for the continued safety
of your child. When used for playing, NEVER leave child
unattended
! To reduce the risk of SIDS, pediatricians recommend healthy
infants be placed on their back to sleep, unless otherwise advised
by your physician.
! CAUTION: Keep small parts and plastic bags out of reach of small
children
! NEVER use plastic shipping bags or other plastic film as mattress
covers not sold and intended for that purpose. They can cause
suffocation
WARNING!
Strings can cause strangulation! NEVER
place items with a string around a child's neck, such as hood
strings or pacifier cords
! NEVER suspend strings over a crib or attach strings to toys.
NEVER use this product if there are any loose or missing fasteners,
Use only mattress provided by
manufacturer, which must be at least 38 inches long by 24
inches wide and not more than 3 inches thick.
Ins_CS_81_1220_051811
!
!
!
!
This crib conforms to applicable regulations promulgated by the
Consumer Product Safety Commission.
This crib meets new C.P.S.C. 16 CFR 1220 and
A.S.T.M. 406 Standards.