Kuryakyn 6235 ISO GRIPS FOR METRIC CRUISERS - Manual (Page 2)

PAGE
2
INSTALLATION OF THROTTLE SIDE
STEP 2
Remove the fasteners (usually two Phillips screws) that hold the two halves of the handlebar
switch housings together. Some models also have a throttle cable retainer that must be removed.
Separate the switch housings.
STEP 3 If the bike is equipped with a cable adjusters, adjust them for maximum cable slack (shorten the
cable housing).
STEP 4 Carefully remove the cable ferrules from the throttle twist grip. Careful use of needle nose pliers
can help here — do not damage the cable.
STEP 5 Slide the new ISO-Grip into place and install the throttle cables and ferrules into the new throttle
sleeve in the same manner as they removed from the stock grip.
STEP 6
Re-assemble the switch housings. Adjust the throttle cables. Test for free unrestricted movement
in the throttle. It must operate freely, without any restriction.
STEP 7 Ensure proper brake lever operation and clearance before operating the motorcycle.
ROTATE THROTTLE AND CHECK THAT IT MOVES FREELY AND RETURNS
TO CLOSED BEFORE STARTING BIKE. FAILURE TO PROPERLY ADJUST THE
THROTTLE CABLES COULD RESULT IN LOSS OF CONTROL CAUSING
SERIOUS INJURY OR DEATH.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and maintenance are
required on all fasteners.
INSTALLATION OF CLUTCH SIDE
STEP 8
Remove the existing grip and bar end weight from the handlebars. Using a razor blade or utility
knife, cut the grip lengthwise from the switch housing out towards the end of the grip. Lift up the
outer portion of the grip at the split that was made with the razor blade and peel it away from the
handlebar. This may take some effort, as the grips are glued on from the factory.
STEP 9
With sandpaper or emery cloth remove all grip and adhesive residue from the exposed handlebar.
The surface should be completely clean and slightly roughed from the sanding. With an ammonia
based cleaner or similar degreasing agent and a clean rag, wipe off the exposed handlebar.
METRIC ISO GRIPS
INSTALLATION
-cont.-