Kuryakyn 6190 ISO GRIPS for VALKYRIE - Manual (Page 3)

PAGE
3
STEP 9
Decide if you want the grip’s pads to match the clutch side when the bike is at rest or
underway with the throttle slightly opened. Without adhesive, slide the grip into place and
determine its position. Make a mental note of the location or make a non-permanent mark on
the grip and/or switch housing.
STEP 10
Remove the grip and give the throttle sleeve and inside of the grip a quick wipe with an ammonia
based cleaner to ensure they are free of contaminates. Take the second supplied tube of adhesive
and apply a good amount of glue onto the throttle tube.
WARNING!
IF YOUR BIKE HAS AN OPEN END THROTTLE SLEEVE YOU MUST BE VERY
CAREFUL NOT TO GET GLUE BETWEEN THE SLEEVE AND THE BAR. THIS WILL
PERMANENTLY GLUE THE BAR TO THE SLEEVE LEAVING IT INOPERATIVE.
Note: Cutting a slit in a thin piece of cardboard, such as the back card from the grip package, so that it
can fit around the handlebar next to the switch housing, will help keep any glue that is plowed up
away from the housing when performing this next step. After completing this next step, remove
the cardboard.
STEP 11 Slide the grip into place, rotating it clockwise as you slide it on to help distribute the glue
evenly and keep the grip from “plowing” glue up against the switch housing. Be prepared to
quickly wipe away any excess glue being “plowed” up by the grip that could be forced up against
the switch housing. Once in place, squeeze the grip firmly to press the rubber against the bar and
hold for 15 seconds. Full bonding will occur in 24 hours.
CAUTION! Rotate throttle and check that it moves freely and returns to closed before
starting bike.
ATTENTION!
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will not
issue a warranty on components lost due to improper installation. Periodic maintenance
may be required.
Ride On!
ISO GRIPS/VALKYRIE
INSTALLATION