Kuryakyn 5487 HEADLAMP ADAPTER HARNESS for 14-UP TOURING - Manual (Page 2)

PAGE
2
BIKE PREP:
STEP 2
Remove the main fuse; refer to your service manual for specific instructions.
STEP 3 Remove and disconnect the headlamp; refer to your service manual for specific instructions.
Proceed onto the model specific installation instructions below.
INSTALLATION (EXCEPT FLHR/C):
STEP 4 Refer to PIC 1. Apply some of the included dielectric grease to the open ends of the connectors.
Connect the new 4-pin adapter to the existing 4-pin connector.
STEP 5 Connect the new 3-pin connector to the new headlight.
STEP 6
Reinstall the main fuse; turn the ignition on and ensure proper headlight function before installa-
tion.
STEP 7 Install the new headlight.
STEP 8 Ensure proper function of ALL lights BEFORE operating the motorcycle.
FLHR/C INSTALLATION:
STEP 9 Cut the existing headlight connectors off of the bike. Refer to PIC 1. Cut the 4-pin connector off
of the new Adapter Harness. Discard the 4-pin connector; it will not be used.
STEP 10 Strip the wires; use the included butt connectors to connect the matching color wires. The blue
wire will not be used; wrap it with electrical tape to insulate it. Connect both black wires from
the bike to the one black wire on the Harness; use an included Large Butt Connector.
STEP 11 Reinstall the headlight; reinstall the main fuse.
STEP 12 Ensure proper function of ALL lights BEFORE operating the motorcycle.
HEADLAMP ADAPTER HARNESS for ‘14-UP TOURING INSTALLATION
Ride On!
Kuryakyn recommends the use of the included dielectric
grease on ALL electrical connections.
Kuryakyn recommends the use of the included dielectric
grease on ALL electrical connections.
It is the end user’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcy-
cle. Küryakyn will not provide warranty coverage on products or compo-
nents lost due to improper installation or lack of maintenance. Periodic in-
spection and maintenance are required on all fasteners.
PIC 1
4-PIN CONNECTS
TO BIKE WIRING
3-PIN CONNECTS TO
NEW HEADLIGHT
USED TO CONNECT
POSITION LAMP ON
SOME INTERNATIONAL
MODELS
12V “KEYED” POWER
FLHR/C ONLY!
CUT HERE