Kuryakyn 1790 UNIVERSAL DRINK RING W/BEVERAGE HOLDER - Manual (Page 2)

PAGE
2
STEP 2
Determine which side of the motorcycle that you would like to mount the
Mirror Mount. Remove that mirror.
Ensure that the installation of this product does not
interfere with the proper operation of the motorcycle
before riding.
It is the installer’s responsibility to ensure that there is
adequate clearance between the Drink Ring/Beverage Holder
and any painted surfaces. Küryakyn is not responsible for
any damage due to inadequate clearance.
STEP 3 Determine the orientation of the Mirror Mount so that it will not interfere
with any component on the motorcycle. (The typical mounting position is
opposite the direction of the mirror head (PIC 1), but it may be positioned
in front of the mirror (PIC 2), or behind the mirror, to clear handlebars
and other accessories.) Insert the threaded portion of the mirror through
the mirror mount. Place the included internal tooth lock washer under the
Mirror Mount and thread the mirror back to the mount on the motorcycle.
PIC 3 (Depending on the area of installation you may need to use
the included flat washer between the internal tooth lock washer
and the Mirror Mount to give the Mount a level surface.
Confirm proper thread depth engagement between the mirror
and the perch. The mirror should thread in to the perch
1-1/2 times it’s thread diameter.
Use the supplied anti-seize for fasteners; this will prevent
galling and make future removal of fasteners easier.
STEP 4
To mount the Universal Drink Ring, place the stud through the Mirror
Mount, lining up the edges of the flats on the stud with the notches in the
Mirror Mount. PIC 3 Place the flat washer first, then the lock washer over
the protruding end (PIC 4). Apply anti-seize to the threaded portion of
the stud and secure with the thumb nut.
STEP 5
Turn the handlebars in both directions to their full stop position and
ensure that there is clearance between the Universal Drink Ring and the
gas tank, dash and other accessories.
ENSURE THAT THERE IS CLEARANCE AT ALL
POINTS WHEN THE HANDLEBARS ARE TURNED,
INSUFFICIENT CLEARANCE MAY CAUSE DAMAGE TO
THE MOTORCYCLE OR CAN CAUSE LOSS OF CONTROL
THAT COULD RESULT IN SEVERE INJURY OR DEATH.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and maintenance are
required on all fasteners.
DRINK RING/BEVERAGE HOLDER
INSTALLATION
-cont.-
PIC 1
PIC 2
PIC 3
PIC 4
MOUNT OPPOSITE OF MIRROR HEAD
MOUNT IN FRONT OF MIRROR HEAD
INTERNAL
TOOTH LOCK
WASHER
GOES HERE
LINE UP EDGES OF
FLATS WITH NOTCHES
FLAT WASHER
LOCK WASHER
THUMB NUT