Kuryakyn 8825 SPLINED ADAPTER mount - Manual (Page 2)

InstallatIon
WARNING! YOU WILL BE WORKING AROUND THE ENGINE AND EXHAUST SYSTEM DURING
INSTALLATION. ENSURE THAT THE ENGINE AND EXHAUST SYSTEM HAVE FULLY
COOLED TO PREVENT INJURY.
steP 2 Remove the hardware securing the footpeg to the footpeg mount; set it aside, it will be re-used.
steP 3 Remove the existing footpegs from the mounts and set them aside, they will not be re-used.
steP 4 Test fit the tube spacer over the removed OEM footpeg mounting
pin.
note The spacer may not be needed in some applications.
steP 5 If the spacer fits over the mounting pin, insert an
included spacer in one of the Splined Adapter Mounts as shown in
PIC.1. The spacer is press fit.
steP 6 Thread a 1/4-20 x 3/8 SSS into the lower hole in the Adapter Mount
as shown in PIC.1. Ensure that the hex head end of the setscrew is threaded
into the Adapter Mount so that it can be accessed from the through hole in the
splined face. See PIC.1.
steP 7 for foldIng floorboards that requIre a solId mount. Thread a #10-
32 x 1 SSS into the upper hole in the Adapter mount as shown in PIC.1. Install flush with the back of the
adapter. Ensure that the hex head end of the setscrew is threaded into the Adapter Mount so that it can be
accessed through the hole in the splined face. See PIC.1.
note The four “D” Spring Washers have been included to take up excessive freeplay and add
tension for folding pegs in the “up position”. They will not be necessary in some instances.
Install the “D” Spring Washers on either side of the Splined Adapter Mount with the flat of
the “D” facing inboard.
steP 8 Install the Adapter Mount in the footpeg or floorboard mount on the motorcycle using the
hardware removed in STEP 2.
steP 9 Adjust the angle of the Adapter Mount. Insert the correct size hex wrench in the lower
hole in the splined face of the Adapter Mount and turn the setscrew clockwise for a higher angle and
counterclockwise for a flatter angle.
steP 10 for foldIng floorboards that requIre a solId mount. Insert the correct
size hex wrench through the top hole in the splined face of the Adapter Mount and turn the setscrews
clockwise until they contact the footpeg mount on the motorcycle. This will “lock” the Adapter Mount in
place against the footpeg mount on the motorcycle
steP 11 Install the new footpeg or floorboards on the Adapter Mount. Refer to the instructions
included with the new footpegs for more information.
ATTENTION! It is the installer’s responsibility to ensure that all of the fasteners (including pre-assembled)
are tightened before operation of the motorcycle. Küryakyn will not warranty components
lost due to improper installation. Periodic maintenance may be required.
steP 12 Repeat STEP 2 through STEP 11 for the other side.
CAUTI ON! Ensure that the installation of this product does not interfere with the proper operation
of the motorcycle before riding.
WARNING! IMPROPER INSTALLATION OR USE OF THIS PRODUCT COULD RESULT IN SERIOUS
INJURY OR DEATH.
Ride On!
Page
2
s P l I n e d a d a P t e r m o u n t
InstallatIon
PIc.1
access the
setscrews from
the holes In the
front
sPacer Is
Press fIt
#10-32 sss
(see InstructIons
for solId mount
floorboars)
1/4-20 sss