Kuryakyn 8818 SPLINED ADAPTER mount User Manual
Page 2

INSTALLATION
STRICTLY OBSERVE ThE fOLLOWING GUIDELINES IN ORDER TO USE ThE
PRODUCT PROPERLY AND AVOID POTENTIALLY DANGEROUS ACCIDENTS.
PROCEDURE
STEP 1
Park the motorcycle on a hard, level surface; turn off the ignition and allow the engine to
cool.
WARNING! YOU WILL BE WORKING AROUND THE ENGINE AND EXHAUST SYSTEM DURING
INSTALLATION. ENSURE THAT THE ENGINE AND EXHAUST SYSTEM HAVE FULLY
COOLED TO PREVENT INJURY.
STEP 2
Remove the hardware securing the footpeg to the footpeg
mount; set it aside, it will be re-used.
STEP 3
Remove the existing footpegs from the mounts and
set them aside, they will not be re-used.
STEP 4
Test fit the tube spacer over the removed OEM
footpeg mounting pin.
NOTE
The spacer may not be needed in some applications.
STEP 5
If the spacer fits over the mounting pin, insert an included spacer
in one of the Splined Adapter Mounts as shown in PIC.1. The spacer is
press fit.
STEP 6
Thread a 1/4-20 x 3/8 SSS into the lower hole in the Adapter Mount as shown in PIC.1.
Ensure that the hex head end of the setscrew is threaded into the Adapter Mount so that it can be
accessed from the through hole in the splined face. See PIC.1.
STEP 7 fOR fOLDING fLOORBOARDS ThAT REQUIRE A SOLID MOUNT.
Thread
a #10-32 x 1 SSS into the upper hole in the Adapter mount as shown in PIC.1. Install flush with
the back of the adapter. Ensure that the hex head end of the setscrew is threaded into the Adapter
Mount so that it can be accessed through the hole in the splined face. See PIC.1.
NOTE
The four “D” Spring Washers have been included to take up excessive freeplay and
add tension for folding pegs in the “up position”. They will not be necessary in some
instances. Install the “D” Spring Washers on either side of the Splined Adapter Mount
with the flat of the “D” facing inboard.
STEP 8
Install the Adapter Mount in the footpeg or floorboard mount on the motorcycle using
the hardware removed in STEP 2.
STEP 9
Adjust the angle of the Adapter Mount. Insert the correct size hex wrench in the lower
hole in the splined face of the Adapter Mount and turn the setscrew clockwise for a higher angle
and counterclockwise for a flatter angle.
STEP 10 fOR fOLDING fLOORBOARDS ThAT REQUIRE A SOLID MOUNT.
Insert
the correct size hex wrench through the top hole in the splined face of the Adapter Mount and turn
the setscrews clockwise until they contact the footpeg mount on the motorcycle. This will “lock”
the Adapter Mount in place against the footpeg mount on the motorcycle
STEP 11
Install the new footpeg or floorboards on the Adapter Mount. Refer to the instructions
included with the new footpegs for more information.
PAGE
2
S P L I N E D A D A P T E R M O U N T
INSTALLATION
PIC.1
ACCESS ThE
SETSCREWS fROM
ThE hOLES IN ThE
fRONT
SPACER IS
PRESS fIT
#10-32 SSS
(SEE INSTRUCTIONS
fOR SOLID MOUNT
fLOORBOARS)
1/4-20 SSS