Bernina 8 SERIES V29.39.00 - Manual (Page 2)

Information on Software Update
BERNINA 830 / 820
Software Version 3
1 General Changes 3
1.1 Language “Finnish” integrated 3
1.2 Display of data version number 3
2 Sewing Updates 4
2.1 Thread tension for the underlay segments (buttonholes) 4
2.2 Manual threading 5
2.3 The use of straight stitch feet with thread cutting 5
2.4 Disable automatic thread cutting when opening the bobbin door 5
2.5 Thread cutting without fabric movement 5
2.6 “Manual” winding of the lower bobbin thread 5
2.7 Winding indicator during sewing/embroidery 6
2.8 Reset of back stepping history 6
2.9 Thread breakage hint 7
2.10 Problem with Foot #57D and straight stitch plate compatibility 7
2.11 Presser Foot #0 can be used for automatic threading. With the “Walking foot”
automatic threading is not possible 8
2.12 Information Foot #2a corrected 8
2.13 Pattern #169 improved 9
2.14 Tension changed for the “tie on” stitches 9
2.15 Upper thread detection changed 9
3 Embroidery Updates (BERNINA 830 only) 10
3.1 Start of embroidery 10
3.2 Using zoom option with panning 10
3.3 Using Foot #44C (The new CutWork & Echo quilting foot) 10
3.4 Thread tension can be changed to a minimum of 0.5 11
3.5 Stop for manual cutting can be switched off 12
3.6 Manual “tie on” for embroidery 12
3.7 Delay of Start/Stop button reduced for embroidery 13
3.8 Thread breakage during jump stitches 13
3.9 Stitching “without thread”, shown now in embroidery mode 13
4 Important points 13
4.1 Hoop calibration 13
4.2 Feedback issues 13
4.3 Free memory 13
2/14, 04.11.2009