Kuryakyn 8810 FRONT FOOTPEG ADAPTERS for YAMAHA - Manual (Page 2)

PAGE
2
STEP 4 Install the Footpeg Adapter as you would the existing footpeg. Ensure that the squared off
end of the Footpeg Adapter is on the bottom when installed. Ensure that
the curved end of the spring locates over the Footpeg Adapter.
STEP 5 Install the hardware in the reverse order it was removed in STEP 2.
NOTE:
Push down on the spring to install the pivot pin.
ATTENTION!
It is the installer’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the
motorcycle. Küryakyn will not warranty components lost due to
improper installation. Periodic maintenance may be required.
STEP 6
Repeat STEP 2 through STEP 5 for the other side.
WARNING! THE INSTALLATION OF AFTERMARKET PEGS MAY AFFECT GROUND
CLEARANCE WHEN CORNERING.
WARNING! IMPROPER INSTALLATION OR USE OF THIS PRODUCT COULD RESULT
IN SERIOUS INJURY OR DEATH.
CAUTION! Ensure that the installation of this product does not interfere with the proper
operation of the motorcycle before riding.
Ride On!
FRONT FOOTPEG ADAPTERS
INSTALLATION
FIG 1