Ride on, Roulette horn cover, Installation – Kuryakyn 7689 ROULETTE HORN COVER User Manual
Page 2

PAGE
2
STEP 2
Remove the set screw from the “U” clip in the bottom of the
Roulette horn cover. Remove the “U” clip, paying attention
to orientation of the threaded portion of the clip.
STEP 3
On the inside of the cover there are two ridges that will clip
over the top edge of the horn. PIC 1 Tip the cover to slide
these over the edge of the horn, then press the bottom of
the cover in place.
STEP 4
Insert the “U” clip (removed in Step 2) in the slot on the
bottom of the Roulette Horn Cover. Make sure the threaded
portion of the clip is inside the Cover. PIC 2
STEP 5
Insert the #6-32 (removed in Step 2) set screw into the
“U” clip and tighten until snug.
It is the installer’s responsibility to ensure that
all of the fasteners (including pre-assembled) are
tightened before operation of the motorcycle.
Küryakyn will not issue a warranty on
components lost due to improper installation.
Periodic maintenance may be required.
Ride On!
ROULETTE HORN COVER
INSTALLATION
PIC 1
PIC 2
PIC 3
HORN LIP CLIPS UNDER THESE RIDGES
THREADED PORTION OF “U” CLIP GOES INSIDE COVER
TIGHTEN SET SCREW SNUGLY AGAINST HORN