Kuryakyn 7259 CLUTCH CABLE ADJUSTER COVER - Manual (Page 2)

PAGE
2
NOTE:
Use care performing the next step. The Adjuster Cover
may scratch the nylon cable housing.
STEP 4
Starting with the smaller opening of the inner cover as close to
the top of the adjuster as possible (PIC2), snap it over the cable
housing. Carefully slide the Cover down over the adjuster. PIC 3
Snap the bottom of the inner cover over the adjuster.
DO NOT use a pliers or other tool to snap the covers
over the adjuster. Tools will scratch the surface of
the Cable Adjuster Covers.
STEP 5
Slide the bottom of the outer cover over the inner cover. Snap
the top of the outer cover over the inner. PIC 4
NOTE:
You may leave the rubber clutch cable adjuster cover
from Step 2 slid down the cable and out of harms way or
remove it.
Ride On!
CLUTCH ADJUSTER CABLE COVER
INSTALLATION
PIC 1
PIC 3 PIC 4
SMALLER OPENING LARGER OPENING
SMALLER OPENING
OVER CABLE THEN DOWN
OVER ADJUSTER
SLIDE BOTTOM UP OVER INNER
SNAP TOP OVER INNER
SNAP THE BOTTOM OVER THE ADJUSTER
PIC 2