Kuryakyn 1698 TECH-CONNECT DEVICE HOLDER for PERCH MOUNT - Manual (Page 2)

PAGE
2
STEP 2
Place a clean, soft blanket over the gas tank to protect the paint.
Ensure that the installation of this product does
not interfere with the proper operation of the
motorcycle before riding.
It is the installer’s responsibility to ensure that there
is adequate clearance between the Tech-Connect and
any painted surfaces. Küryakyn is not responsible for
any damage due to inadequate clearance.
Be aware of any cables/wires that could potentially
be pinched or crushed while using this product.
STEP 3
Remove the bottom screw securing the clutch perch halves. Set
this aside, it will not be used again.
STEP 4
Identify the correct screw, either the metric or standard, by
comparing threads on the included screws to the threads from
the screws that were removed. The 1/4”-20 x 2-1/4” screws are
generally used on older H-D motorcycles, the 1/4”-20 X 2” screws on newer
Harleys and the M6 X 1.0 X 55mm on Metric bikes.
Use the supplied anti-seize for fasteners; this will prevent galling and
make future removal of fasteners easier.
STEP 5
As shown in PIC 2, insert the two included spacers into the two slots in the perch
mount. Place a washer over one of the button socket cap screws, then insert it
through the bottom spacer on the perch mount arm. Add a dab of anti-seize to the
screw end.
STEP 6
As shown in PIC 3, place the arm, screw, washer and spacer on the perch and
start the screw. Finger tighten the screw.
STEP 7
Remove the upper screw securing the perch mounting halves; it will not be used
again. PIC 3
STEP 8
Rotate the arm up into position and install the screw, and washer while using a
dab of anti-seize on the screw end. PIC 4
STEP 9
Tighten both of the screws securely.
STEP 10 Install the Tech-Connect holder to the handlebar mount by inserting the metal
shaft through the hole in the handlebar mount. The hex flats on the metal shaft
will line up with the hex flats in the hole. PIC 5 Secure the Tech-Connect with the
included 1/4” flat washer, then the 1/4” lock washer, then the Acorn nut. PIC 6
Tighten securely.
STEP 11
Turn the handlebars in both directions to their full stop position and ensure that
there is clearance between the mounting plate/accessory and the gas tank, dash
and other accessories.
ENSURE THAT THERE IS CLEARANCE AT ALL POINTS WHEN
THE HANDLEBARS ARE TURNED, INSUFFICIENT CLEARANCE
MAY CAUSE DAMAGE TO THE MOTORCYCLE OR CAN CAUSE
LOSS OF CONTROL THAT COULD RESULT IN SEVERE INJURY
OR DEATH.
It is the installer’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcycle.
Küryakyn will not issue a warranty on components lost due to improper
installation. Periodic maintenance may be required.
TECH-CONNECT DEVICE HOLDER
INSTALLATION
-cont.-
PIC 2
PIC 3
PIC 4
PIC 1
1/4” FLAT WASHERS
SPACERS
BUTTON SOCKET CAP
PERCH MOUNT
BUTTON SOCKET CAP SCREW AND FLAT WASHER
SPACERS
REMOVE
THIS SCREW