Kuryakyn 7279 SABERTOOTH L.E.D. SADDLEBAG ACCENTS - Manual (Page 3)

PAGE
3
STEP 11
Route the wiring along the inboard side of the saddlebag as shown in PIC 4. Secure the wiring
with the included Cable Keepers. Position the Cable Keepers in the “recesses” of the saddlebag to
ensure proper clearance once the saddlebag
has been reinstalled.
STEP 12 Repeat STEPS 4 through 11 for the
other side.
STEP 13 Reinstall both saddlebags.
CONNECT THE WIRING:
STEP 14
Carefully remove the seat and left side cover.
STEP 15
Refer to PIC 5. Behind the side cover, locate the 8-pin rear-accessory con-
nector. Remove the rubber cap (or separate the connectors if there are
rear accessories installed).
STEP 16 Refer to PIC 6. Apply some Dielectric Grease to the open ends of the in-
cluded Victory 8-Pin Adapter and rear accessory connector. Connect the
Adapter to the accessory connector. If equipped, connect the existing rear
accessory plug to the other end. Reinstall the rubber cap (if necessary)
STEP 17 Refer to PIC 6. Apply Dielectric Grease to the 3-pin connectors and con-
nect the wiring from the clutch-side (left) Accent to the SHORT 3-pin lead
coming from the 8 pin adapter.
STEP 18
Apply Dielectric Grease to the 3-pin connectors and connect the wiring
from the brake-side (right) Accent to the LONG 3-pin lead coming from
the 8 pin adapter.
STEP 19 Turn on the ignition and test for the proper function of all the lights.
STEP 20 Use the included Cable Ties to secure any extra wiring away from heat,
pinch points or moving parts.
STEP 21 Reinstall the side cover, and seat.
NOTE:
Disconnect both 3-pin connectors when removing the
saddlebags.
SABERTOOTH L.E.D. SADDLEBAG ACCENTS
Ride On!
INSTALLATION
Secure all wiring away from any moving parts, pinch
points or extreme heat. Kuryakyn WILL NOT issue a
warranty for any electrical component that fails due
to pinched, crimped, broken, abraded, melted or
frayed wires.
THE 8-PIN ACCESSORY CONNECTOR IS LOCATED
BEHIND THE CLUTCH-SIDE (LEFT) SIDE COVER
PIC 5
APPLY DIELECTRIC
GREASE TO THE
OPEN END OF THE
CONNECTOR
Kuryakyn recommends the use of the included
dielectric grease on ALL electrical connections.
VISIBILITY IS A MAJOR CONCERN FOR MOTORCYCLISTS. A
LIGHTING MALFUNCTION COULD RESULT IN DEATH OR SERIOUS
INJURY. ENSURE THAT ALL LIGHTS OPERATE PROPERLY BEFORE
RIDING THE MOTORCYCLE.
PIC 6
3-PIN CONNECTORS
VICTORY 8-PIN
ADAPTER
SHORT
(LEFT)
LONG
(RIGHT)
PIC 4
USE THREE CABLE
KEEPERS PER SIDE
CLUTCH-SIDE (LEFT)