Kuryakyn 7627 CHROME CYLINDER BASE COVER for VICTORY - Manual (Page 2)

PAGE
2
STEP 2 Remove the two existing screws shown in PIC 1; set them within arms
reach of the work area, they will be reused.
STEP 3 Refer to PIC 2. Locate the included brake-side (Right) Cylinder Base Cover,
Front Bracket, Rear Weldment, Long and Short Rods, and three (3) M5
Screws.
STEP 4 Refer to PIC 3. Secure the Short Rod to the peak of the Cover with one of
the M5 screws; hold the rod with one hand while tightening the
screw.
STEP 5
Refer to PIC 3. Use the Long Rod to “sandwich” the Front
Bracket against the front of the cover; secure the Rod and
Bracket with one of the M5 screws; leave it loose for now.
STEP 6 Refer to PIC 3. Secure the Rear Weldment to the rear of the
Cover with one of the M5 screws; leave it loose for now.
STEP 7 Refer to PIC 3. Carefully slide the Cover into place; adjust the
Weldment as necessary to clear the exhaust.
Once in place, align the weldment and bracket holes with the
engine case holes; secure with the two screws removed in
STEP 2 ; leave the screws loose for now.
NOTE: If equipped, remove the Kuryakyn Primary
Cover before continuing the installation.
STEP 8 Locate the included clutch-side (Left) Cylinder Base Cover and
remaining two (2) M5 Screws.
STEP 9 Refer to PIC 4. Carefully align the Left Cover holes with the Short
and Long Rod Ends; secure the Cover to the Rods with the two M5
Screws; leave them loose for now.
Ensure that the two rubber bumpers on the on the inside edge of the
Left Cover remain in place as it is installed under the cylinder fins.
STEP 10 Ensure that the Covers do not contact any other parts, then tighten
all the screws.
STEP 11
Reinstall the Kuryakyn Primary Cover (if equipped).
CHROME CYLINDER BASE COVER for VICTORY INSTALLATION
Working around the sharp edges of the cylinder-head fins exposes
your hands to injury. Wear protective gloves to prevent serious in-
jury.
FRONT
BRAKE-SIDE (RIGHT)
REMOVE THESE TWO SCREWS
PIC 1
PIC 3
FRONT
BRAKE-SIDE (RIGHT)
SLIDE SHORT
ROD BETWEEN
ENGINE “V”
LONG ROD
BELOW FRONT
CYLINDER
PIC 4
FRONT
CLUTCH-SIDE (LEFT)
SHORT ROD END
LONG ROD END
REMOVE EXISTING PRIMARY
COVER (IF EQUIPPED)
Ride On!
It is the end user’s responsibility to ensure
that all of the fasteners (including pre-
assembled) are tightened before operation
of the motorcycle. Kuryakyn will not provide
warranty coverage on products or compo-
nents lost or damaged due to improper in-
stallation or lack of maintenance. Periodic
inspection and maintenance are required on
all fasteners.
PIC 2
SHORT
LONG
FRONT
REAR WELDMENT
BRAKE-SIDE (RIGHT)
FRONT BRACKET