Kuryakyn 1500 UNIVERSAL DRINK HOLDER - Manual (Page 3)

PAGE
3
STEP 11
Turn the handlebars in both directions to their full stop position and ensure that there is clearance
between the Universal Drink Holder and the gas tank, dash and other accessories.
ENSURE THAT THERE IS CLEARANCE AT ALL POINTS WHEN THE
HANDLEBARS ARE TURNED, INSUFFICIENT CLEARANCE MAY CAUSE
DAMAGE TO THE MOTORCYCLE OR CAN CAUSE LOSS OF CONTROL THAT
COULD RESULT IN SEVERE INJURY OR DEATH.
STEP 12 Tighten all hardware.
BEVERAGE
CARRIER INSTALLATION
STEP 1
Hold the Beverage Carrier under the Drink Ring.
STEP 2 As shown in PIC 2, each of the three straps will go around the drink ring
from the outside to the inside.
STEP 3 Snap each of the three arms to the snaps (PIC 2) located inside the drink
holder.
TO PREVENT POSSIBLE LOSS OF CONTROL, WHICH COULD RESULT IN A
POSSIBLE INJURY OR DEATH, WE DO NOT RECOMMEND REMOVING AND
REPLACING OBJECTS IN THE HOLDER WHILE RIDING THE MOTORCYCLE.
Do not overload the Drink Ring/Beverage Carrier with excessive weight.
The adjustability of the Drink Ring/Beverage Carrier was not intended to prevent
spills.
Ensure that the Drink Ring/Beverage Carrier is secure on the Mount and that the
Mount is secure on the motorcycle. Küryakyn is not responsible for any belongings
that are stolen or damaged from use of this Drink Holder or from the
Drink Ring/Beverage Carrier or Mount not being properly secured to the
motorcycle. It is the installer’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcycle.
Küryakyn will not provide warranty coverage on products or components lost due
to improper installation or lack of maintenance. Periodic inspection and
maintenance are required on all fasteners.
UNIVERSAL DRINK HOLDER
INSTALLATION
Ride On!
PIC 2
FOLD STRAPS FROM
OUTSIDE TO INSIDE