Kuryakyn 833 THE SOUND OF CHROME-GEN 3 for 1 BARS - Manual (Page 3)

PAGE
3
STEP 11
Remove the seat.
STEP 12
Find a location under the seat (or some other out of the way area) to mount/locate
the noise filter, and that the power wires from the filter will reach the terminals on
the battery. PIC 3
STEP 13 Secure the noise filter with cable ties or by removing a screw from the bike and
placing it through the tab on the filter and then reinstalling the screw.
STEP 14 Route the harness from the noise filter under the gas tank towards the
handlebars. Use the include cable ties from the hardware kit to secure the wiring
harness out of the way of pinch points, extreme heat and moving parts.
ATTENTION!
Secure all wiring away from any moving parts, pinch points or extreme
heat. Küryakyn WILL NOT warranty any electrical component that fails
due to pinched, crimped, broken, abraded, melted or frayed wires.
STEP 15
Refer to PIC. 4 and connect the wiring harnesses together using dielectric grease
from the hardware kit on the connections. The shorter stereo plug harness is to be
used when mounting an audio player on the handlebars.
ATTENTION! Küryakyn recommends the use of dielectric grease on electrical
connections.
NOTE: The additional audio extension may be used to place the audio player in
additional locations i.e. saddlebag, trunk or bag; by routing the wire under
the gas tank in same manner that the power harness was installed in
STEP 14.
STEP 16 Bundle the excess wire together with a cable tie. Secure in a location that is out of
the way, and away from, pinch points, moving parts or extreme heat.
NOTE:
Make sure that the bundle of wires is located in a position so the audio jack will reach
the audio player when using a handlebar accessory mount.
STEP 17
Connect the power wires from the noise filter to the terminals on the battery.
STEP 18
The black wire from the filter is a ground wire and needs to be secured to the negative terminal
on the battery.
STEP 19
The red wire from the filter (with in-line fuse) is a power wire and needs to be secured to the
positive terminal on the battery.
STEP 20 Make sure that all wiring is secured away from pinch points, moving parts and extreme heat.
ATTENTION! Secure all wiring away from any moving parts, pinch points or extreme heat. Küryakyn
WILL NOT warranty any electrical component that fails due to pinched, crimped, broken,
abraded, melted or frayed wires.
STEP 21 Reinstall the seat.
ATTENTION!
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will not
warranty components lost due to improper installation. Periodic maintenance may be
required.
WARNING! DO NOT ATTEMPT TOOPERATE THE SPEAKER VOLUME SWITCH OR ADJUST
YOUR MUSIC DEVICE WHILE OPERATING THE MOTORCYCLE.
Ride On!
THE SOUND OF CHROME-GEN 3
INSTALLATION
PIC 4
SIX PIN PLUG
CONNECTS SPEAKER TO
3 WAY HARNESS
TWO PIN HARNESS CONNECTS
TO THE 3 WAY HARNESS TO THE
FUSE AND NOISE FILTER
HARNESS
3 PIN HARNESS IS FOR
THE AUDIO JACK
STEREO PLUG
HARNESS
STEREO EXTENSION
HARNESS
FUSE AND
NOISE FILTER
HARNESS
NOISE FILTER
PIC 3