Kuryakyn 1448 SCYTHE II MIRRORS - Manual (Page 2)

It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and
maintenance are required on all fasteners
STEP 2
Remove the stock mirrors from controls; set them aside, they will not be re-used.
MOUNTING WITH SINGLE SCREW
STEP 3 Determine which of the included socket head cap screws from the hardware kit will
provide maximum thread engagement in the mirror stem without bottoming out.
STEP 4
Place a split lock washer over the socket head cap screw and insert it in the hole in
the hand control. FIG 1
STEP 5
Place an internal lock washer over the protruding end of the cap screw.
STEP 6 While holding the mirror in place, thread the socket head cap screw into the
bottom of the mirror stem.
NOTE: Ensure that the setscrew in the mirror stem does not prevent the socket
head cap screw from being installed fully. FIG 1
STEP 7 Adjust the position of the mirror stem for visibility and clearance; tighten the
socket head cap screw and then the setscrew.
STEP 8
Repeat STEP 3 through STEP 7 for the opposite side.
H-D with Bottom Mounted Turn Signals—
Right Side Procedure
Removing the retainer nut and/or the ball stud clamp in the
next Step will release the turn signals from the hand controls.
Secure the turn signals to prevent damage or injury .
STEP 9 Loosen and remove the retainer nut and ball stud clamp shown in FIG 2
STEP 10 Remove the stock mirror; hold the stock turn signal to prevent it from being
damaged.
STEP 11
Screw a double ended stud into the new mirror stem; tighten and then tighten the
set screw. FIG 2
NOTE: Ensure that the setscrew in the mirror stem does not prevent the double
ended stud from being installed fully. FIG 2
STEP 12 Place an internal lock washer over the long end of one of the double-ended studs;
insert the assembly into the mirror stem hole in the hand control. FIG 2
STEP 13 Place a split lock washer over the protruding end of the double-ended stud and
thread the retainer nut onto the stud. FIG 2
STEP 14 Adjust the position of the mirror stem for visibility and clearance; tighten the
retaining nut.
STEP 15 Install the ball stud clamp onto the retainer nut; adjust the turn signal and
tighten the clamp.
STEP 16 Repeat STEP 3 through STEP 7 for the LEFT SIDE.
STEP 17 Adjust the mirrors for proper view before riding the motorcycle.
PAGE
2
Ride On!
SCYTHE II MIRRORS
INSTALLATION
FIG 1
MIRROR
INTERNAL
LOCK
WASHER
HANDLEBAR CONTROL
LOCK WASHER
SOCKET HEAD CAP SCREW
SETSCREW
FIG 2
STOCK TURN SIGNAL
RETAINER NUT
LOCK WASHER
HANDLEBAR
CONTROL
INTERNAL
LOCK WASHER
DOUBLE ENDED STUD
SETSCREW
MIRROR
BALL STUD CLAMP
BALL STUD
LOCK NUT