Ride on, Ergo ii with dually iso pegs, Installation – Kuryakyn 4056 ERGO II/6 ARMS with DUALLY ISO PEGS User Manual
Page 3
PAGE
3
STEP 9
Repeat Steps 2 through 8 for the right side.
ADJUSTING THE POSITION OF SWINGARM AND
DUALLY
ISO
PEGS
STEP 10
Adjust for Longer or Shorter Inseam Lengths:
•
Loosen the 1/2”-13 Button Head Fastener securing the swingarm to the
mount. Pull the swingarm out of the interlocking cogs.
•
Rotate the swingarm to the desired position then push the arm back
into the interlocking cogs; be sure the swingarm is either level with the
engine guard, or above the engine guard. NEVER position the
swingarm below the engine guard! FIG 1 Retighten the 1/2”-13
fastener.
IT IS THE INSTALLERS RESPONSIBILITY TO ENSURE
THERE IS SUFFICIENT CORNERING CLEARANCE
BEFORE RIDING. ALWAYS POSITION THE SWINGARM
EITHER LEVEL WITH, OR ABOVE THE ENGINE GUARD.
POSITIONING THE SWINGARM BELOW THE ENGINE
GUARD WILL GREATLY DECREASE CORNERING
CLEARANCE WHICH MAY CAUSE LOSS OF CONTROL
RESULTING IN SERIOUS INJURY OR DEATH.
STEP 11
Adjust the Clevis Angle:
• Loosen the 1/2”-13 Hex Head fastener securing the swingarm to the
clevis. Pull outward on the clevis and Dually ISO Peg to clear the roll
pins.
•
Rotate the clevis and Dually ISO Peg assembly to the desired angle then push the assembly
back into the swing arm, making sure the roll pins in the clevis line up with the holes on the
swingarm, and re-tighten the fasteners. Install the black thread plug in the swingarm. PIC 4
STEP 12
Adjust the Peg Angle:
Loosen the peg adjustment fastener (PIC 4)and rotate the peg to the desired position. Re-tighten
the
fastener.
STEP 13
PIC 4 shows the complete assembly.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and maintenance are
required on all fasteners.
Ride On!
ERGO II with DUALLY ISO PEGS
INSTALLATION
FIG 1
PIC 4
BLACK PLUG
GOES HERE
LOOSEN THIS FASTENER
TO ADJUST PEG