Kuryakyn 7574 TOUR TECH CRUISE MOUNTS - Manual (Page 2)

PAGE
2
STEP 2
While looking at the engine guard, determine your preference of the final height of the Tour Tech
mounts.
STEP 3
On the mounts, remove the large main mounting bolt, this is the point
where the arm pivots on the clamp. PIC 1
STEP 4
Fold the clamp around the engine guard in your desired location. Be sure
the head of the hinge pin is facing up. The “cogged” face of the clamp
should face outward from the bike. PIC 1 and PIC 2
STEP 5 Re-install the offset arm on the clamp. Be sure the 1/2” nylon washer is in
place between the two clamp “ears.” PIC 2 and PIC 3
NOTE: This washer is cosmetic only. When the clamp is tightened, the
“ears” of the clamp may not touch the washer.
STEP 6
Position the offset arm to your liking. Tighten the main mounting bolt
securely. PIC 3
STEP 7 Install your choice of male mount footpegs.
NOTE: Make sure that when the footpeg is in the “folded up” position, that
it is not resting or rubbing on the fairing lower.
POSITION THE TOUR TECH ARMS AND PEGS SO THEY
DO NOT INTERFERE WITH THE OPERATION OF THE
FOOT CONTROLS. INTERFERENCE WITH THE FOOT
CONTROLS MAY CAUSE LOSS OF CONTROL RESULTING
IN SERIOUS INJURY OR DEATH.
CHECK TO MAKE SURE THAT THERE IS PROPER
GROUND CLEARANCE FOR CORNERING. LOSS OF
CONTROL OF THE MOTORCYCLE AND SERIOUS INJURY
MAY OCCUR IF THE PEG/ARM IS NOT POSITIONED
PROPERLY. REPOSITION THE TOUR TECH MOUNT IF
NECESSARY SO THAT THERE IS ADEQUATE CORNERING
CLEARANCE.
STEP 8 See PIC 4. Note the two small tapped holes in the backside of the foot peg
clevis area. The setscrew should be positioned in the lower of the two holes.
By running the setscrew in or out, the angle of the foot peg may be
adjusted.
STEP 9
Periodically check the tightness of all fasteners.
It is the installer’s responsibility to ensure that all of the
fasteners (including pre-assembled) are tightened before
operation of the motorcycle. Küryakyn will not provide
warranty coverage on products or components lost due to
improper installation or lack of maintenance. Periodic
inspection and maintenance are required on all fasteners.
Ride On!
TOUR TECH CRUISE MOUNTS
INSTALLATION
PIC 4
ADJUST PEG ANGLE HERE WITH SET SCREW
IN BOTTOM HOLE
PIC 3
MAIN MOUNTING
BOLT
PIN HEAD UP PIC 2
MAKE SURE TO PUT NYLON WASHER HERE
COGGED PORTION FACES OUT
RIGHT SIDE
SHOWN
PIC 1
MAIN
MOUNTING
BOLT
COGS FACE OUT
RIGHT SIDE
SHOWN