Kuryakyn 7579 PREMIUM MINI BOARD without ADAPTER - Manual (Page 2)

PAGE
2
STEP 2
Remove the stock peg from the peg mount. Pay attention to any spacers or washers installed
between the peg mount and the clevis, it may be helpful later. Keep the mounting hardware, it
may be reused.
STEP 3
Install the new peg adapter as per the instructions with the peg adapter. Check that the peg
adapter is installed correctly and the adapter is able to fold up.
MINI BOARDS MUST BE INSTALLED SO THEY WILL FOLD UPWARD AND
REARWARD IF HIT BY ANY OBJECT. FAILURE TO ADJUST THE MINI
BOARDS TO OPERATE IN THIS MANNER COULD RESULT IN SERIOUS
INJURY OR DEATH
STEP 4
There are three mounting holes with splines around them in the Mini Board. Use these to locate
the Board forward or rearward, tilt up or down, from the stock peg location. Once you have
decided on the location and orientation, insert the 5/16”-18 socket head cap screw, with flat
washer, through the Board and thread it into the adapter making sure the splines on the Board
are engaged in the splines on the adapter in the desired location. Tighten securely.
ENSURE THAT THE INSTALLATION OF THESE MINI BOARDS DOES NOT
INTERFERE WITH THE PROPER OPERATION OF THE MOTORCYCLE BEFORE
RIDING. INTERFERENCE WITH THE CONTROLS OR ANY COMPONENT ON
THE MOTORCYCLE MAY CAUSE LOSS OF CONTROL RESULTING IN
SERIOUS INJURY OR DEATH.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and maintenance are
required on all fasteners.
Ride On!
PREMIUM MINI BOARDS
INSTALLATION