Kuryakyn 7120 CHROME UPPER FORK SHROUD for VICTORY - Manual (Page 2)

PAGE
2
BIKE PREP:
STEP 2 Refer to PIC 1. On the clutch-side (left) lower triple clamp, loosen the upper
screw. Remove the wiring clip; it will not be reused. Tighten the screw and
torque to 17 ft/lbs.
STEP 3 Refer to PIC 2. Using warm soapy water and a soft clean rag, remove any
grease, oil, dirt, and other debris from all external surfaces of both front
forks. Rinse the forks with clean water and allow them to completely dry.
STEP 4 Using the included alcohol pads, wipe the cleaned areas in PIC 2 to remove any wax or
polish. Allow the areas to completely dry.
INSTALL THE LOWER SHROUDS:
STEP 5 Test fit the Lower Right Front ( B ) and Rear ( D ) Shrouds as shown in PIC 3 and 4. The
flanged edges of the Front Shroud ( B ) will fit over the edges of the Rear Shroud ( D ).
NOTE: TYPICAL INSTALLATION—Align the seam of the Lower Front and
Rear Shrouds inline with the axle. The seam can be positioned in
any orientation with the flange on (B) facing the front or outside.
STEP 6 Remove the Shrouds. Using your fingernail, rub the backing to activate the adhesive on
the Lower Right Rear Shroud (
D ). Refer to PIC 5 . Remove the backing.
STEP 7
One at a time, press the Lower Shrouds into place starting with the Rear Shroud (
D
).
The flanged edges of the Front Shroud ( B ) will fit over the edges of the Rear Shroud
( D ).
CHROME UPPER FORK SHROUD for VICTORY INSTALLATION
-cont.-
Ensure proper adhesion of this product. Clean the instal-
lation area of grease, oil, bugs, dirt and other debris
(including wax and polish). Küryakyn WILL NOT issue a
warranty for any improperly installed products.
Do not attempt this installation in temperatures below
50° F. Proper adhesive bonding ONLY occurs above 50°
PIC 4
B
D
BRAKE-SIDE (RIGHT)
ALIGN THE SEAM
INLINE WITH AXLE
PIC 3
D
BRAKE-SIDE (RIGHT)
LOWER RIGHT REAR SHROUD DEPICTED
ALIGN THE SEAM
INLINE WITH AXLE
PIC 5
PIC 2
CLEAN THE FORKS
BRAKE-SIDE (RIGHT)
UPPER
LOWER
PIC 1
LOOSEN SCREW. REMOVE
CLIP. TORQUE SCREW
TO 17 FT/LBS
WIRING CLIP
CLUTCH-SIDE (LEFT) LOWER TRIPLE CLAMP