Kuryakyn 7630 BAHN CLUTCH COVER ACCENT FOR VICTORY - Manual (Page 2)

PAGE
2
STEP 3
Align the two holes in the new BAHN cover with the threaded holes in the engine case. PIC 1 The
cover can be mounted with the holes oriented horizontally or vertically (shown in PIC 2).
STEP 4 Secure the cover with the included M6 screws. Torque the screws to 15 in. lbs.
TIPS FOR PROPER CARE:
Your new BAHN product is made out of anodized aluminum. Anodized aluminum requires special
attention when cleaning. Some cleaning products or procedures can actually remove the anodized
treatment which will lead to pitting in the aluminum.
Thoroughly clean the BAHN product often with a soft cloth, mild soap and water. Regular cleaning
keeps contaminates from building up.
Rinse thoroughly with FRESH water.
Use only metal protection products that are formulated for anodized aluminum.
DO NOT USE bleach or chlorides to clean the BAHN product.
DO NOT USE products containing abrasives to clean the BAHN product. Never use steel or brass
wool, wire brushes, polishing wheels, rubbing or polishing compounds on the Bahn product.
DO NOT USE concentrated alkaline based solutions to clean the BAHN product. Many detergents
are alkaline based.
BAHN CLUTCH COVER ACCENT FOR VICTORY
INSTALLATION
PIC 2
SECURE WITH M6
SCREWS. TORQUE
TO 15 IN LBS
It is the installer’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcy-
cle. Küryakyn will not issue a warranty on components lost due to improper
installation. Periodic maintenance may be required.
Ride On!
PIC 1 DECIDE WHICH WAY YOU WOULD LIKE THE HOLES TO BE ORIENTED
(HORIZONTALLY OR VERTICALLY).