Kuryakyn 1656 PLUG AND GO DRIVER BACKREST — VICTORY - Manual (Page 2)

PAGE
2
STEP 1
Read and understand all steps in the instructions before starting the installation. Park the motor-
cycle on a hard, level surface and turn off the ignition.
BIKE PREP:
STEP 2 Remove the seat.
STEP 3 Refer to PIC 1. Remove the two screws securing the passenger safety strap; set the screws aside
the will not be reused.
STEP 4 Using warm soapy water and a clean rag, remove all grease, oil, dirt and other debris from the
area shown in PIC 1. Allow the area to dry completely.
STEP 5
Locate the included Rubber Bumper Strip. Rub the adhesive backing with your finger nail to acti-
vate the adhesive; remove and discard the backing. Press the Rubber Bumper into place as shown
in PIC 1 for one minute.
ASSEMBLE THE RECEIVER:
STEP 6 Refer to PIC 2. Locate the included
Spacers, Lock Washers, Flat Washers,
Hex Head Screws, and Receiver.
STEP 7 Assemble the hardware, safety strap
and receiver as shown in PIC 2.
PLUG AND GO DRIVER BACKREST — VICTORY
-cont.-
INSTALLATION
PIC 1
FIRST,
REMOVE
THE SAFETY
STRAP
THEN, CLEAN THIS
AREA AND PRESS
THE RUBBER STRIP
INTO PLACE
PIC 2
SPACER
STRAP BRACKET
FLAT WASHER
LOCK WASHER
HEX HEAD SCREW
FRONT
RECEIVER
SET SCREW (STEP 12)
TENSION SCREW (STEP 10)