beautypg.com

Velociraptor air cleaner for yamaha, Installation – Kuryakyn 9518 VELOCIRAPTOR AIR CLEANER for YAMAHA User Manual

Page 2

background image

PAGE

2



STEP 2

Remove existing air cleaner cover, filter element, and backing plate; save the
three socket head cap screws for later use.


OPTIONAL:

(950 Models Except Bolt) — Refer to PIC 1. Remove the two
screws to remove the OEM support bracket, it will not be
used; reinstall and tighten the screws. Refer to the service
manual for correct torque specs.


STEP 3

Refer

to

PIC 2. Disconnect the breather hose from the back-

side of the backing plate. Ensure the spring clip remains on
the hose; it will be reused. Set the backing plate aside, it will
not be reused.


STEP 4

Refer

to

PIC 2. Remove the lower screw from the timing

chain tensioner housing. Set the screw aside; it will not be
reused.

STEP 5

Refer

to

PIC 2. Remove the front Phillips head screw from

the bottom of the throttle body. Set the screw aside; it will
not be reused.

STEP 6

Refer

to

PIC 3. Locate the included Mounting Bracket. Secure

the Mounting Bracket to the underside of the throttle body
with an included M5 X 0.8 X 14MM Socket Head Cap Screw
and M5 Split Lock Washer. Leave the Screw finger tight for
now.

NOTE:

Remove one Phillips head screw at a time
to prevent dislodging the plate and O-ring
it secures.

STEP 7

Remove the rear screw from the underside of the throttle
body. Refer to PIC 3. Swing the Mounting Bracket in until the
holes align; secure the Bracket with the other M5 Screw and
Lock Washer. Leave the Screw snug for now.


STEP 8

Align the Mounting Bracket slot with the hole in the timing
chain tensioner housing; thread the included M6 Socket Head
Cap Screw with Flat Washer through the slot and into the
tensioner housing. Leave the Screw snug for now.


STEP 9

Tighten the two M5 Screws from

STEP 6 and 7

. Do NOT over

tighten the Screws. Tighten the
M6 Screw from

STEP 8

.

STEP 10

Refer

to

PIC 4. Thread the in-

cluded 1/2” Elbow Hose Fitting into
the included Air Cleaner Adapter.
Ensure the Fitting points inward
when installed.

STEP 11

Refer

to

PIC 4. Install the included

Rubber Inlet Flow Plate in the
Adapter as shown.

VELOCIRAPTOR AIR CLEANER for YAMAHA

-cont.-

INSTALLATION

THROTTLE BODY

REMOVE THE
FRONT SCREW

REMOVE THE
LOWER

SCREW FROM
TIMING CHAIN

TENSIONER
HOUSING

PIC 2

BREATHER HOSE

PIC 3

PIC 4

90 DEGREE
FITTING

POINTS
INWARD

INSTALL RUBBER INLET FLOW PLATE
IN BACKSIDE OF ADAPTER. ENSURE

PLATE FULLY SEATS IN RECESS

Working around the sharp edges of the cylinder-head fins exposes
your hands to injury. Wear protective gloves to prevent serious in-

jury.

MOUNTING BRACKET

FRONT OF BIKE

PIC 1

BRAKE-SIDE (RIGHT)

REMOVE THE TWO SCREWS TO REMOVE BRACKET