Kuryakyn 7287 CHROME LED SPEAKER BEZELS - Manual (Page 4)

PAGE
4
STEP 21 Apply dielectric grease to each connector. Connect one of the included Turn Signal Pigtails as
shown in PIC 10 on PAGE 3 . Repeat STEP 20 and 21 for the other side.
BEZEL WIRING (ALL YEARS):
STEP 22 Connect one of the included Black 3-Pin Connectors to one of the white 3-pin connectors on the
Wiring Adapter (from
STEP 19 or 21 , depending on the model year).
STEP 23
Refer to PIC 11 and 12. Push the pin terminal from the RED wire of the Speaker Bezel
into the Black 3-Pin Connector across from the BLUE wire (’06 through ‘13 Wiring
Adapter) or the RED wire (’00 through ’05 Wiring Adapter). Ensure the lock tabs on
the terminals lock into place in the connector.
STEP 24 Refer to PIC 13. Push the pin terminal from the BLACK wire into the 3-Pin Connector
across from the BLACK wire on the Wiring Adapter. Ensure the lock tabs on the termi-
nals lock into place in the connector. Repeat for the other side.
STEP 25 Reinstall the main fuse. Turn the ignition on and make sure the Speaker Bezels and all other lights
work properly; turn the ignition off when you are done checking. Reinstall
the side cover.
STEP 26
Secure the wires up and out of the way of pinch points with the included
Cable Ties.
STEP 27 Refer to PIC 14. Seal the notches drilled in the inner fairing with some of
the included silicone. The silicone fully cures in 24 hours.
STEP 28 Reconnect the headlight and reinstall the outer fairing in the reverse order
it was removed.
CHROME LED SPEAKER BEZELS
Ride On!
INSTALLATION
INCLUDED BLACK 3-PIN
CONNECTOR
INSERT THE BLACK WIRE IN
THE MIDDLE PIN LOCATION
INSERT THE RED WIRE ACROSS FROM THE BLUE (‘06—’13) OR THE RED WIRE (‘00 THROUGH ‘05)
PIC 13
THE LOCK TABS ON THE TERMINALS
SHOULD “SNAP” IN PLACE IN THE SLOTS
WHITE 3-PIN CONNECTOR
FROM WIRING ADAPTER
PIC 11
RED TO BLUE ON ‘06—’13
PIC 12
RED TO RED ON ‘00—’05
Secure all wiring away from any moving parts, pinch
points or extreme heat. Kuryakyn WILL NOT provide
warranty coverage on any electrical component that
fails due to pinched, crimped, broken, abraded,
VISIBILITY IS A MAJOR CONCERN FOR MOTORCYCLISTS. A LIGHT
MALFUNCTION COULD RESULT IN DEATH OR SERIOUS INJURY.
ENSURE PROPER LIGHT OPERATION BEFORE RIDING THE MOTOR-
CYCLE.
It is the end user’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcy-
cle. Küryakyn will not provide warranty coverage on products or compo-
nents lost or damaged due to improper installation or lack of maintenance.
Periodic inspection and maintenance are required on all fasteners.
Dielectric grease inhibits moisture and prevents corrosion. Kuryakyn recom-
mends the use of the included dielectric grease on ALL electrical connections.
Apply dielectric grease directly to mating surfaces.
PIC 14
SEAL WITH SILICONE