Kuryakyn 1338 LED WINDSHIELD TRIM FOR FLTR — CHROME - Manual (Page 3)

PAGE
3
INSTALL THE LED WINDSHIELD TRIM:
STEP 13 Refer to PIC 4. Carefully mark and drill a 7/16” hole 1 1/2” from the holes towards the center and
3/4” up from the ledge as shown in PIC 4.
STEP 14 Refer to PIC 5. Determine the left Trim from the right.
STEP 15 Refer to PIC 6. Insert the left side Trim wire through the left side hole
drilled in the STEP 13 . Repeat for the other side.
STEP 16 Refer to PIC 7. Insert the well nuts with rubber wash-
ers in their holes.
STEP 17
Remove four (4) of the plastic washers from the OEM
windshield screws and place them on the included
windshield trim stand offs; set them within arms reach
of the work area. Leave one OEM screw with plastic
washer for use in the next step
STEP 18 Hold the windshield in place; insert the OEM screw with
plastic washer through the center windshield hole and
into the well nut, then snug the screw.
NOTE: Refer to PIC 8. Ensure that there is
some slack in the wiring before fully
securing the windshield to the fair-
ing.
STEP 19
Refer to PIC 9. Insert the windshield trim stand offs
through the remaining holes in the windshield and well nuts. Alternately tighten the OEM screw
and stand offs.
LED WINDSHIELD TRIM FOR FLTR — CHROME INSTALLATION
-cont.-
FRONT OF FAIRING
PIC 4
1 1/2”
3/4”
DRILL A 7/16”
HOLE HERE DRILL A 7/16”
HOLE HERE
CLUTCH-SIDE (LEFT)
BRAKE-SIDE (RIGHT)
1 1/2”
3/4”
CLUTCH-SIDE (LEFT)
BRAKE-SIDE (RIGHT)
PIC 5
PIC 6
7/16”
HOLE
FRONT OF FAIRING
PIC 7
INSERT WELL NUTS AND RUBBER
WASHERS THROUGH HOLES
PIC 9
WINDSHIELD STAND-OFFS
WHILE WINDSHIELD IS
STILL LOOSE, ENSURE
THAT THERE IS SOME
SLACK IN THE WIRING
PIC 8
MEASURE TWICE – DRILL ONCE . Double check all reference marks made on
the fairing BEFORE drilling. Kuryakyn will not be responsible for incidental or
consequential damages resulting from this installation.