Kuryakyn 7238 BAHN SPEEDO/TACH ACCENT 96-13 TOURING - Manual (Page 2)

STEP 2
Refer to PIC 1. Using soap and water, clean the installation area. Allow to dry. Wipe the area with
an ammonia-based cleaner and allow it to dry completely.
STEP 3 Position the BAHN
Speedo/Tach Accent
as shown in PIC 2.
Use masking tape to
make alignment
marks. Remove the
Accent.
STEP 4 Refer to PIC 3.
Using your fin-
gernail, rub the
adhesive backing
on the backside
of the Accent to
activate the ad-
hesive. Remove
and discard the
backing.
STEP 5 Using the marks made in STEP 3 , align the
Accent. Press it into place for one minute.
Full bonding will occur after 24 hours. Re-
move and discard the masking tape.
NOTE: If the bike is going to be op-
erated before the full bond-
ing takes place, secure the
accent to the inner fairing
with a good quality masking
tape or painter’s tape.
BAHN SPEEDO/TACH ACCENT ‘96-’13 TOURING INSTALLATION
TIPS FOR PROPER CARE:
Your new BAHN product is made out of anodized aluminum. Anodized aluminum requires special at-
tention when cleaning. Some cleaning products or procedures can actually remove the anodized
treatment which will lead to pitting in the aluminum.
Thoroughly clean the BAHN product often with a soft cloth, mild soap and water. Regular cleaning
keeps contaminates from building up.
Rinse thoroughly with FRESH water.
Use only metal protection products that are formulated for anodized aluminum.
DO NOT USE bleach or chlorides to clean the BAHN product.
DO NOT USE products containing abrasives to clean the BAHN product. Never use steel or brass
wool, wire brushes, polishing wheels, rubbing or polishing compounds on the Bahn product.
DO NOT USE concentrated alkaline based solutions to clean the BAHN product. Many detergents are
alkaline based.
Ride On!
PAGE
2
THOROUGHLY CLEAN THIS AREA
PIC 1
PIC 2
PIC 3