Kuryakyn 1663 FIXED MOUNTS FOR MULTI-PURPOSE BACKREST - Manual (Page 2)

PAGE
2
NOTE:
Due to the great variety of seats available, to determine the
correct mount height needed, measure the thickness of the front
of the passenger seat. Measure from the top of the rear fender to
the top of the passenger seat as in PIC 1. Over 6 inches need the
tall mounts, 6 inches and under will use the short mounts.
STEP 2 Locate the left and right side (sitting on bike) mounting brackets. PIC 2
STEP 3
Remove the saddlebags to expose the rear fender struts.
STEP 4
Remove the three OEM fasteners on the right side shown in PIC 3.
STEP 5 Starting with the right side Fixed Mount, insert one of the 5/16”-18 x 1”
button socket cap screws through one of the 5/16” flat washers and into
the front hole of the Fixed Mount. PIC 4 Loosely attach the Fixed Mount
to the front location on the strut.
STEP 6
Insert one of the 5/16”-18 X 2” button socket cap screws with a 5/16”
flat washer through each rear hole of the mounting bracket. Place one of
the included spacers over the threads of each screw (PIC 4) and attach
the rear of the Fixed Bracket to the motorcycle. Torque the front and
rear hardware to 14 FT/LBS.
STEP 7 Repeat Steps 4, 5 and 6 for the left side.
STEP 8 Test fit the Driver/Passenger Backrest between the fixed mounts. The
Backrest should slide easily between the fixed mounts. If it slides in
easily, proceed to Step 10. If the Backrest seems to bind or you have to
spread the Fixed Mounts apart to insert the Backrest, proceed to the next
Step.
STEP 9
Remove the button head cap screws securing each Fixed Mount to the
bike and insert one of the remaining 5/16” flat washers between the
Fixed Mount and each of the spacers and between the front of the Fixed
Mount and the strut, on each button head cap screw. PIC 5 and PIC 6
Torque to 14 FT/LBS.
STEP 10
Install the Driver/Passenger Backrest to the Fixed Mounts by inserting
one of the supplied (with the backrest)
5/16”-18 X 7/8” countersunk socket head cap
screws through one of the supplied shoulder
washers, through the Fixed Mount and threading
it to the Driver/Passenger Backrest on each side.
PIC 7 Torque to 15 FT/LBS. If these
fasteners are loosened or removed, see
WARNING! on the next page!
FIXED MOUNTS
INSTALLATION
PIC 1
MEASURE FROM
THE TOP OF
FENDER TO TOP
OF PASSENGER
SEAT
LEFT SIDE
RIGHT SIDE
PIC 2
PIC 3
REMOVE THESE THREE FASTENERS
PIC 4
SPACERS
BUTTON SOCKET CAP SCREWS
FLAT WASHERS
-cont.-