Ride on, Rear lighting kit, Installation – Kuryakyn 5416 REAR LIGHTING KIT for FLHTCUTG/FLHXXX User Manual
Page 3
PAGE
3
STEP 11
Apply a little of the included dielectric grease to the male 3-pin connector from the
Pulsating Brake Light Controller and plug it into the female connector on the
Tour-Pak harness.
STEP 12
Start the motorcycle and test to make sure that the lights function correctly and
the brake light pulses.
NOTE:
Check for proper turn signal operation. If the turn signals flash rapidly,
you may need to synchronize the turn signal system. Do this by turning
one turn signal on for 5 flashes. Turn that signal off and turn on the other
signal for 5 flashes. Turn the motorcycle off. Turn the motorcycle on and
verify the signals flash at the correct rate.
If the turn signals continue to
flash fast or erratically, you will need to install the included
Self-Regulating Load Equalizer as in the following Step.
STEP 13
Locate the Self-Regulating Load Equalizer from the hardware kit. Place a small
amount of dielectric grease to the male 3-pin connector on it and plug it into one
of the small female 3-pin connectors on the Pulsating Brake Light Controller.
PIC 4
NOTE:
This Load equalizer will compensate for front and rear L.E.D. turn signals.
All Küryakyn or other load equalizers will need to be removed.
NOTE:
When using the four-way flashers the load equalizer will turn off. The
alarm “key” indicator light on the dash will light. This will not effect the
operation of the turn signals and will reset when the four way flashers are
turned off and the ignition switch is turned off.
NOTE:
Abnormally prolonged activation of a turn signal may cause the alarm “key” indicator to
light and or cause the turn signal to flash rapidly. Turning the turn signal off and
allowing the equalizer to cool will restore normal flashing. The alarm “key” indicator
will remain lit, but the motorcycle will function normally, until the ignition is turned off,
to
reset
the
load
equalizer.
NOTE:
If, after the load equalizer is installed, the turn signals flash rapidly, you may need to
synchronize the load equalizer to the turn signal system. Do this by turning either turn
signal on for 5 flashes. Turn that signal off and turn on the other signal for 5 flashes.
Turn the motorcycle off. Turn the motorcycle on and verify the signals flash at the
correct
rate.
ENSURE PROPER LIGHT OPERATION BEFORE RIDING THE MOTORCYCLE.
VISIBILITY IS A MAJOR CONCERN FOR MOTORCYCLISTS. A LIGHT
MALFUNCTION COULD RESULT IN DEATH OR SERIOUS INJURY.
STEP 14
Reinstall the Tour-Pak liner.
STEP 15
Replace the seat after all wires have been secured. Make sure no wires or connectors are pinched.
AFTER INSTALLING THE SEAT, PULL UP ON IT TO ENSURE IT IS LOCKED
INTO PLACE. A LOOSE SEAT CAN SHIFT AND CAUSE LOSS OF CONTROL
RESULTING IN SERIOUS INJURY OR DEATH.
Secure all wiring away from any moving parts, pinch points or extreme heat.
Küryakyn WILL NOT issue a warranty on any electrical component that fails due to
pinched, crimped, broken, abraded, melted or frayed wires.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and maintenance are
required on all fasteners.
Ride On!
REAR LIGHTING KIT
INSTALLATION
PIC 3
PIC 4
TOUR-PAK HARNESS
TO PULSATING BRAKE
LIGHT CONTROLLER
LOAD EQUALIZER TO
PULSATING BRAKE
LIGHT CONTROLLER