Kuryakyn 7277 CHROME PASSING LAMP TRIM RINGS - Manual (Page 2)

PAGE
2
STEP 7
Hold the lamp in the housing and position the Chrome Passing Lamp Trim Ring over the top of it.
PIC 3 and 4
NOTE: Ensure that the notches in the lamp and the tab on the lamp
ring are still aligned.
STEP 8 Gently push the Chrome Trim Ring onto the housing. Ensure that the
flange on the backside of the Chrome Trim Ring fits in the groove in the
lamp housing.
STEP 9
Insert an included Phillips Pan Head Screw through the holes in the bot-
tom of the Chrome Trim Ring. PIC 5
STEP 10 Hold the Custom Nut in the position shown in PIC 5. Begin threading the
screw into the nut.
STEP 11 Ensure that everything is still aligned, then tighten the screw. DO NOT
OVER TIGHTEN THE SCREW. The Trim Ring and lamp should be snug.
If it is difficult or impossible to get the flange on the
backside of the Chrome Trim Ring to properly engage
the groove in the lamp housing, replace the lamp ring
with the included Foam Spacer Strips
Remove Chrome Trim Ring. Unplug the lamp and re-
move the lamp ring. Set the lamp ring aside, it
will not be re-used.
Peel paper backing off the included Foam Spacer
Strips.
Stick the Foam Spacer Strips to the outside edge
of the lamp. PIC 6
Re-install the lamp and Chrome Trim Ring
(without the lamp ring) as outlined in STEPS 7
through 11. Ensure the lamp is aligned with the
top side up.
STEP 12
Test passing lamp
CHROME PASSING LAMP TRIM
-cont.-
INSTALLATION
PIC 1
REMOVE EXISTING SCREW, NUT AND TRIM
RING.
PIC 2
ALIGN NOTCHES IN LAMP
RING WITH BOSSES ON
LAMP
ALIGN TAB ON LAMP
RING AND NOTCH IN
HOUSING
PIC 3
HOLD LAMP IN PLACE. ENSURE EVERYTHING IS
ALIGNED BEFORE INSTALLING CHROME TRIM
RING
PIC 5
THREAD THE SCREW INTO
ONE OF THE CUSTOM NUTS
CHROME PASSING LAMP TRIM RING
PHILLIPS PAN HEAD SCREW
TIGHTEN SCREW SNUGLY. DO NOT OVER
TIGHTEN THE SCREW. SEE THE NOTICE
ABOVE
HOLD THE EXISTING TRIM RING AND LAMP
PIC 4
HOLD THE TRIM RING AND LAMP IN
POSITION
LAMP RING