Kuryakyn 7865 BLACK NECK COVERS - Manual (Page 3)

PAGE
3
When installing the neck covers, you will need to slightly push down
while tightening the top fastener. This will allow adequate clearance
between the top of the neck covers and the inner fairing or headlight
shroud when the bars are rotated all the way side to side.
STEP 12
Tighten the 5/16”-18 x 1-1/4” screws that secure the covers and the tank.
STEP 13
Tighten the #10-24 X 2-1/2” screw that secures the top halves of the covers
together.
STEP 14
Tighten the screws from STEP 13 that secure the down tube cover clamps to the
covers.
STEP 15
Secure the clutch cable to the down tube in the same location that the cable tie that was removed
in STEP 2 was located.
STEP 16 Turn handlebars in both directions to their full stop position to make sure that the clutch cable,
throttle cables, wiring or any other component of the motorcycle, is not stretched or pinched.
ENSURE THAT THE CLUTCH CABLE, THROTTLE CABLES, WIRING OR ANY
OTHER COMPONENT OF THE MOTORCYCLE IS NOT PINCHED OR
STRETCHED AT ANY POINT WHEN THE HANDLEBARS ARE TURNED TO
THEIR FULL STOP POSITION ON EITHER SIDE. STRETCHED OR PINCHED
COMPONENTS CAN CAUSE LOSS OF CONTROL THAT COULD RESULT IN
SERIOUS INJURY OR DEATH.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and maintenance are
required on all fasteners.
Ride On!
BLACK NECK COVERS
INSTALLATION
PIC 4
#8-32 X 1/2” SOCKET
HEAD CAP SCREWS
DOWN TUBE
COVER CLAMP