Kisan Electronics 10APF - Manual (Page 4)

- 4
OPERATION:
After you have installed the 10APF FUSE, turn the ignition key on and
activate the turn signals. The turn signals should begin flashing and stop
after 10 seconds. This is the factory default time-out. You can program
different time-out, as shown below.
PROGRAMMING TIME-OUT INTERVALS
n
Turn the ignition key on and activate the turn signals
o
Let the flashing cycle time-out then CANCEL the handlebar switch
p
Now, re-activate turn signals for ONE FLASH ONLY – cancel it after
q
Repeat above step two more time - needs (3) one flash activations
This will change the time-out to 20 seconds interval. Reprogramming once
more will change it to 30 seconds interval.
If after installing, 10APF FUSE fails to operate correctly, see below.
REVERSE POLARITY
If the Input/Output connection is reversed,
the turn signal bulbs will continue flashing
and not time-out. The blue STATUS LED
will not be illuminated during flashing. This
built-in protection of the 10APF FUSE
prevents any damage to the unit and bike’s
wiring.
If you simply plugged it in the wrong way or were unsure or simply made a
mistake in identifying the correct power wire for turn signal relay, this
feature will help you find out what went wrong during installation.