Kisan Electronics P75W - Manual (Page 5)

MOUNTING DAYLIGHT SENSOR
Day Light Sensor should be mounted on the dash or fairing. It should not
be facing the front of the motorcycle, in order to avoid false triggers at
night from on-coming vehicles.
You can zip-tie the Sensor to a brake cable or a bracket, as long as it
receives unobstructed sunlight. The sense head is sealed to be
waterproof.
You can also choose a permanent mount in fairing or side pockets.
FLUSH MOUNT
n
Chose an appropriate location for the
Daylight Sensor - it faces skyward and
should receive unobstructed sunlight.
o
Start with a small pilot hole. Finish with
a 3/8” -enlarged a little- (10mm) hole.
p
Feed the Sensor from behind the panel.
q
Insert the Split Bushing around the
cable, as shown.
r
Move the Bushing up toward the
threaded neck of the Sensor.
s
Push the assembly firmly in the hole,
until it locks-in - do not pull the cable.
The sensitivity is adjustable for different levels of daylight. Depending on
the location you have chosen to mount the Sensor. Or due to seasonal
changes in weather conditions you may want to choose a different level.
Instructions are described in more detail on the next page.
Note! Programming of Daylight Sensor’s sensitivity IS NOT REQUIRED. In
most cases the default factory setting will suit most common riding environment.