Kisan Electronics P75W - Manual (Page 4)

P-75W INSTALLATION: P-75W INSTALLATION:
Locate the hi-beam wire using a
Voltmeter or a test light. Once
you have identified the hi-beam
wire and chosen the correct
location to install pathBlazer, cut
and strip the wire ends about ¼”.
Crimp the insulated tab
connectors supplied and plug
them onto the pathBlazer. Locate the hi-beam wire using a
Voltmeter or a test light. Once
you have identified the hi-beam
wire and chosen the correct
location to install pathBlazer, cut
and strip the wire ends about ¼”.
Crimp the insulated tab
connectors supplied and plug
them onto the pathBlazer.
RESET PROCEDURE
n
Remove any over-load. Do not exceed MAX 75W limit.
o
TURN HI-BEAM ON first. Then turn the ignition on (4) times –
once every second.
p
If the over load condition is no longer present, pathBlazer will
begin modulation properly.
No ground wire connection is
required and the metal housing of the unit does not have to be grounded
Plug the Daylight Sensor in the pathBlazer as shown.
No ground wire connection is
required and the metal housing of the unit does not have to be grounded
Plug the Daylight Sensor in the pathBlazer as shown.
CIRCUIT PROTECTION CIRCUIT PROTECTION
„ If the Input/Output connection is reversed, the hi-beam will remain off.
The blue STATUS LED will not illuminate.
„ If the circuit detects over-load (MAX 75W), hi-
beam will be turned off. The blue STATUS LED
will flash rapidly. Overload detection is
instantaneous and accurate to prevent any
accidental damage due to short-circuit from
pinched or cut wires. Once tipped, the unit will
remain in ‘Tripped Mode’.