B&B Electronics MES1A - Manual (Page 23)

Getting Started
Manual Documentation Number: MES1A/MES1B-2106m PN7138-rev001
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-
europe.com
13
Using the Device Installer Software
This section provides more detailed information on how to install
and use the Device Installer software.
Device Installer is used to set up and configure the MES1A/B on a
network. It detects all MES1A/Bs on the network and allows you to
configure the network and serial port settings. It also allows you to
monitor the MES1A/B and verify its status.
System Requirements
• Windows XP, Windows 2000, Windows NT4.0 (with service
pack 6.0a or later), Windows ME, or Windows 98
• Internet Explorer 5.01 or later
• 30 MB hard drive space
• 64 MB RAM
Installing the Device Installer
Note: Device Installer requires Microsoft .NET software to
operate.
To install the Device Installer software:
1. Insert the CD included with your MES1A/B into the CD
ROM drive of your PC.
2. The installation should launch automatically. If not:
a. Click Start on the Task Bar and select Run
b. Type in [CD drive letter]:\Launch.exe
3. When the Device Installer Setup Wizard dialog box
appears, click Next to open the Select Installation Folder
dialog box.
4. Accept the suggested installation folder or click Browse…
to select a different installation folder.
5. Click Next to open the Confirm Installation dialog box.
6. Click Next to begin the installation. When finished, the
Installation Complete dialog box appears.