Billion Electric Company BILLION BIPAC-7500GL - Manual (Page 49)

Billion BIPAC-7500G / 7500GL 802.11g ADSL VPN Firewall Router with 3DES Accelerator
Chapter 4:Configuration
Conn
Always on:
If you want the router to establish a PPPoA session when starting up and
: If you want to establish a PPPoA session only when there is a
packet requesting access to the Internet (i.e. when a program on your computer attempts
Idle Timeout:
Auto-disconnect the broadband firewall gateway when there is no activity on the
line f
You can define the destination port and packet type (TCP/UDP) without
checking by timer. It allows you to set which outgoing traffic will not trigger and reset the
MTU: Maximum Transmission Unit. The size of the largest datagram (excluding media-
t to send through the interface.
e system after IPCP
(Internet Protocol Control Protocol) negotiation is completed. If set to enabled, a route will
f set to enabled, the route created will only apply to packets for
the subnet at the remote end of the PPP link. The address of this subnet is obtained
local IP interface connected to the PPP
transport. If the value 0.0.0.0 is supplied, the netmask will be calculated from the class of
bnet mask is determined by the IP address of the
remote end of the link. The class of the IP address is obtained during IPCP (Internet
setting enables/disables whether the
primary/secondary DNS server address is requested from a remote PPP peer using IPCP.
r a remote PPP peer. Once IPCP has
ection:
to automatically re-establish the PPPoA session when disconnected by the ISP.
Connect to Demand
to access the Internet).
or a predetermined period of time.
Detail:
idle timer.
RIP:
RIP v1, RIP v2, and RIP v2 Multicast. Check to enable RIP function.
specific headers) that IP will attemp
Advanced Options (PPPoA)
LLC Header:
Selects encapsulation mode, true for using LLC or false for using VC-Mux.
Create Route: This setting specifies whether a route is added to th
be created which directs packets to the remote end of the PPP link.
Specific Route:
Specifies whether the route created when a PPP link comes up is a
specific or default route. I
during IPCP negotiation.
Subnet Mask:
sets the subnet mask used for the
the IP address obtained during IPCP negotiation.
Route Mask: Sets the subnet mask used by the route that is created when a PPP link
comes up. If it is set to 0.0.0.0, the su
Protocol Control Protocol) negotiation.
MRU:
Maximum Receive Unit. This is negotiated during the LCP protocol stage.
Discover Primary / Secondary DNS: This
The default setting for this command is enabled.
Give DNSto Relay:
Controls whether the PPP Internet Protocol Control Protocol (IPCP)
can request the DNS server IP address fo
43