JULABO KRC 180 Refrigerators for chemicals - Manual (Page 12)

CHANGING THE DOOR OPENING SIDE
12
KRC 180
Notice :
Installation, maintenance and repairs on the refrigerator may only be carried out
by qualified personnel.
Before carrying out the procedures mentionned below, disconnect
the refrigerator from the mains socket!
The refrigerators are delivered from the factory with the door hinges on the right.
a) Remove hinge bracket (3) with the door closed. Remove the door downwards.
b) Unscrew hinge pin (2) from bracket (3), and screw it into the adjacent mounting hole.
c) Unscrew hinge pin (5), and screw it into the opposite side of the overhang.
d) Pry out cover piece (4) from the lower left side, and insert to cover the exposed mounting
holes at the right side.
e) Hang the door into hinge pin (5), and close the door.
f) Screw hinge bracket (3) to the left side of the unit, not forgetting the washers.
g) If the door is not in line with the unit housing, readjust its position in the slots of hinge
bracket 3, and tighten all screws firmly.
h) Unscrew door handle (1) from the left side of the door.
i) Pull out plugs (6) from the right side of the door, and insert into the exposed mounting
holes at the left side.
k) Screw door handle (1) to the right side of the door.