Humanscale Keyboard System Installation - Manual (Page 2)

Rear rubber
stopper
Track
Mounting tape
1/2”Back
from edge
5/8” Flat head screws (2) (blue)
1/2” Flat head screws
(2) (red)
Keyboard platform
Keyboard mechanism
Keyboard cord clips (3)
Hex nuts (4)
Front bumper
5/8” Round head screws (2)
5/8” Round head
screws (8)
5/8” Round head
screws (1)
Glides
STEP 1: Using tape, affix track to underside of desk. Using
tapping screws, attach track and rear rubber stopper.
STEP 2: Making sure plastic glides are in place, slide
mechanism into track. Attach front bumper to track.
STEP 3: Attach keyboard platform to mechanism. Attach
keyboard cord clips and mouse cord clips as desired.
(NOTE: For 5G and 6G mechanisms, partially install all four
screws in a crisscross pattern before tightening any of
them down. Hex nuts are not required. For 2G, 4G and KM
mechanisms, use Hex nuts to tighten screws.)