beautypg.com

General safety rules – HMC Electronics PLUTO10D Kolver PLUTO DC Controlled Electric Torque Screwdriver User Manual

Page 3

background image

GENERAL SAFETY RULES

WARNING: when using electric screwdrivers, basic safety precaution
should always be followed to reduce the risk of fire, electric shock and
personal injury. Read all the instructions below before using the
screwdriver and save them.

1.

Keep the work area clean and well lit.

2.

Do not use the electric screwdrivers in dampt or wet locations or in
presence of flammable liquid or gases.

3.

Avoid body contact with grounder surface as pipes, radiator,
refrigerators, etc.

4.

Keep children and visitors away from work area.

5.

When not in use screwdrivers should be stored in dry and locked-up place
and out of the reach of children.

6.

Do not use the screwdrivers for purposes or work not intended.

7.

Dress properly. Do not wear loose clothing and jewelry. Wear protective
hair covering to contain long hair.

8.

Never carry the screwdriver by cable or pull it to disconnect it from
socket.

9.

Use clamps or a vice to hold work.

10. Keep proper footing and balance at all times.
11. Inspect tool cable periodically and, if damaged, have it repaired or

replaced by authorized service facility. Always keep handles dry, clean
and free from oil and grease.

12. Disconnect tools from power supply before any operation of servicing,

when changing accessories and when you do not use them.

13. When screwdriver is used outdoors, only operate with extension cords

intended for use outdoors and so marked .

14. Pay attention while working. Do not operate screwdriver when you are

tired.

15. Always check the screwdriver is not damaged before using it. Detective

switches must be replaced by authorized service center. Never use tools
that cannot be turned on or off by the switch .

16. The use of any other accessory other than recommended in this operating

instruction may represent a risk of personal injury.

17. Have the screwdriver repaired only by authorized and expert people.

Failing to do so may represent a serious danger.

WARNING: before connecting the control unit and power supply to the
socket, please check the voltage you are using is that indicated on the label
of the unit itself.

Documentation Provided By HMC Electronics

33 Springdale Ave. Canton, MA 02021

http://www.hmcelectronics.com

(800) 482-4440

This manual is related to the following products: