Great Northern Popcorn 7976 Frosty Keg Kegerators - Manual (Page 8)

IMPORTANT!
Co IS AN ODORLESS, INVISIBLE GAS DELIVERED
UNDER PRESSURE. ALWAYS HANDLE WITH CARE!
Figure a
Figure b
Figure c
Figure d
Figures e
Figure f
Figure g
Figure g
Figure h
Figure i
It is essential that you review and follow the installation and
precautions on pages 9 and 10 of the manual to avoid injury to yourself
and others. These update pages outline the assembly and adjustment of
the kegerator system and pay particular attention to common problems
that may arise.
To assemble the system:
Locate the beer tower, faucet handle and line ( ), then attach
the faucet handle by screwing it into the faucet top ( ).
2. Next, locate the beer line washer and insert it into the beer line coupler
( ).
This connection is one of the crucial connections in
your system. Be careful to insert the washer so that it is laying flat and
evenly, and when connecting, do not over tighten. Failure of the
washer at this junction can cause loss of pressure and over-foaming.
3. Locate the beer tower washer, and slide it onto the beer line, running
the coupler end through the washer first ( ), then attach snugly
onto the end of the beer tower ( ).
4. Thread the beer line through the hole on the top of the kegerator,
coupler end first ( ). Set the beer tower upright by lining up the
grooves on the bottom of the tower with the grooves on the kegerator
hole’s top. Fit end snugly into hole (
).
Note: The tower will be off-center as shown in , but the next
step will snap and lock it correctly into alignment.
5. Firmly grasp the tower and spigot ( ) and rotate the tower
clockwise until it stops. Take care not to bend the spigot as you do
this. When finished the spigot will face straight ahead. (
).
2
1.
PLEASE NOTE: PLEASE NOTE:
Copyright 2011 DTX International
KEGERATOR ASSEMBLY
STEP BY STEP ASSEMBLY GUIDE
Figure a
Figure b
Figure c
Figure d
Figure e
Figure f
Figure g
8 Figure h
Figure i