Great Northern Popcorn 6301 Vortex Cottaon Candy Machines - Manual (Page 9)

OPERATING PROCEDURES
Cotton Candy Machine Controls & Operation
1. Turn the to by pushing down
on the red switch (Figure M). Observe the stability
of your machine. Check for excessive vibration
and if you notice this, turn the
to
, unplug the machine and make sure that
your working surface is level. Check to see that
the floss head is sitting levelly and evenly.
2. To bring the machine up to temperature, turn the
(Figure N) to .
Allow to heat up for 2-4 minutes; the floss head
will heat to a temperature of around 445 degrees
F, so take care to keep body parts and flammable
materials away when the machine is in operation.
Subsequent batches will not require a preheating
period.
3. After machine is hot, add 1 scoop (with the sugar
ladle provided) of cotton candy floss mixture into
the spinner head (Figure P).
4. Within 5-45 seconds, cotton candy floss will appear (Figure Q, also, see
page 10 for cone-building instructions). Make sure to spin the floss head
until all sugar is gone.
Repeat steps 3-4 to continue spinning floss; once the machine is warmed
up, no preheating is needed.
5. To clean the floss head,
Power Switch ON
Power Switch
OFF
Heating Controller Switch ON
USE CAUTION!
FLOSS HEAD IS SPINNING AT ULTRA-HIGH
SPEEDS. TAKE CARE NOT TO CONTACT THE
SPINNING HEAD WITH YOUR HAND OR THE SCOOP! DO NOT
OVERFILL. OVERFILLING CAN LEAD TO EXCESSIVE SMOKING.
VERY IMPORTANT! FAILURE TO BURN OFF AND SPIN OFF EXCESS
SUGAR COULD LEAD TO SMOKING AND/OR BURNED SUGAR
DURING NEXT RUN CYCLE.
TURN MACHINE OFF, UNPLUG AND ALLOW
TO COOL COMPLETELY, THEN WIPE WITH A CLEAN MOISTENED
WARM SOFT CLOTH. CLEAN MACHINE AFTER EVERY USE.
9
Figure M
Figure N
Figure P
Figure Q
Copyright 2012 DTX International All Rights Reserved