BenQ Digital Projector LX60ST - Manual (Page 36)

Operation 36
4. If the action is successful, you see the message 'Captured Succeeded' on the
screen. The captured picture is saved as MyScreen.
5. To view the captured picture displayed as the startup screen, set MyScreen in the
SYSTEM SETUP: Basic > Splash Screen menu and restart the projector.
• Using the OSD menu
1.
Press MENU/EXIT and then press / until the SYSTEM SETUP: Basic menu
is highlighted.
2. Press to highlight MyScreen and press MODE/ENTER.
3. Repeat steps 2-5 in the "Using the remote control" section to capture and view the
captured picture.
In the unlikely event that the capturing action fails, change your target picture.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speakers. Be
sure you have made a correct connection to the projector audio input. See "Connection"
on page 17 for how the audio input is connected.
Muting the sound
To temporarily turn off the sound:
1.
Press MENU/EXIT and then press / until the SYSTEM SETUP: Advanced
menu is highlighted.
2. Press to highlight Audio Settings and press MODE/ENTER. The Audio
Settings page is displayed.
3. Highlight Mute and press / to select On.
If available, you can also press MUTE on the remote control to toggle projector audio between on and off.
Adjusting the sound level
To adjust the sound level, press VOLUME+/VOLUME- on the remote control, or:
1.
Repeat steps 1-2 above.
2. Press to highlight Volume and press / to select a desired sound level.
Adjusting the microphone volume
To adjust the microphone sound level, press MIC/VOL keys (+/-) on the remote control,
or:
1.
Repeat steps 1-2 above.
2. Press to highlight Microphone Volume and press / to select a desired
sound level.
Turning off the Power On/Off Ring Tone
To turn off the ring tone:
1.
Repeat steps 1-2 above.
2. Press to highlight Power On/Off Ring Tone and press / to select Off.
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound mute or
changing the sound level will not affect the Power On/Off Ring Tone.