Flex Substrate Adhesive 7003 - Manual (Page 2)

_____________________________________________________________________________________________________
Flex Membrane International Corp. 2670 Leiscz’s Bridge Road, Suite 400, Leesport, PA 19533
Tel: (610) 916-9500 Fax: (610) 916-9501 www.FlexRoofingSystems.com
Page 2
specified coverage rate. Apply a smooth even coat of the adhesive over the substrate to insure 100%
coverage. Allow adhesive to become tacky but do not allow a skin to form on the adhesive or allow the
adhesive to dry out. Open times may vary depending on weather conditions and film thickness. Average
open time can be 10 to 30 minutes depending on weather conditions at time of application. Place the Flex
Fleeceback membrane into the adhesive and roll with a heavy (200 lb.) roller to insure contact with the
adhesive
.
PRODUCT HANDLING
Flex Substrate Adhesive contains ingredients which could be harmful if mishandled. Contact with skin
and eyes should be avoided and necessary protective equipment and clothing should be worn.
STORAGE
When Flex Substrate Adhesive is stored indoors, out of direct sunlight, and in the original, unopened
container between 60°F and 80°F, the shelf life is six months. Always rotate stock.
CLEANUP
Fresh coating can be removed with water. Dried Flex Substrate Adhesive can be cleaned with mineral
spirits.
CAUTION
· Do not allow this product to Freeze.
· Keep out of Reach of Children.
· Do not heat container or store at temperatures greater than 120°F.
· Close Container after each use. Do not take internally.
· Use protective measures to avoid contact with eyes and skin.
· If swallowed, call Physician immediately.
· In case of eye contact, open eyelids and flush immediately with plenty of water for at least 15
minutes. GET MEDICAL ATTENTION.
Flex Membrane International Corp. maintains Material Safety Data Sheets on all of its products.
Material Safety Data Sheets contain health and safety information for your development of
appropriate product handling procedures to protect your employees and customers.
Material Safety Data Sheets should be read and understood by all of your supervisory personnel
and employees before using Flex products in your facilities.
LIMITED WARRANTY
We warrant only that this product is free of defects, since many factors which affect the results obtained
from this product such as weather, workmanship, equipment utilized and prior conditions of the substrate,
are all beyond our control. We will replace at no charge any product proved to be defective within 12
months of purchase, provided it has been applied in accordance with our written directions for uses we
recommended as suitable for this product. Proof of purchase must be provided.
Elvaloy® is a registered trademark of DuPont.