Macro commands, Override commands, Log commands – ETC Unison Paradigm Serial Access Protocol (PSAP) User Manual
Page 5: Paradigm serial access protocol (psap), Macro commands override commands log commands, N o t e

E T C C o n f i g u r a t i o n G u i d e
Paradigm Serial Access Protocol (PSAP)
PSAP Configuration Guide
Page 5 of 7
Electronic Theatre Controls, Inc.
Macro Commands
Override Commands
Log Commands
The following commands allow the serial device to temporarily alter logging setup.
Received Data
Resulting Action
macro on macroname
Executes On steps of a macro
macro off macroname
Executes Off steps of a macro
macro tog macroname
Toggles macro state
macro cancel macroname
Cancels execution
macro on Macro 1
executes on steps of Macro 1
Received Data
Resulting Action
ovr enab overridename
Enables override
ovr disab overridename
Disables override
ovr tog overridename
Toggles override state
ovr enab Override 1
enables Override 1
N o t e :
The property set for “Verbose Logging” property in LightDesigner will be restored as
the logging setup after any Paradigm Architectural Control Processor (P-ACP) reboot.
Received Data
Resulting Action
log disabled
Disables logging
log ascii
sets log format to ASCII
log dec
sets log format to decimal
log hex
sets log format to hexadecimal
log get
retrieves the current log setting